215hp street build

[Tripps]

I wouldn't normally hit 4th under full power, 3rd is well over 120 mph

 

[Kevin frazier]

Square is stock and Murdoch is angled, there more cuts but subtle and hard to see, you can see cut line for angle in this example

 

[Kevin frazier]

Crank installed, piston jets in, new bearings in, balance shaft in and dots lined up to crank, gear selector in and the ole @cootertwo dang bolt is loctited and in. Clean clean clean, gonna cover and i have to wait on new input shaft case bearing. New detent spring installed and filed burr of spring tip so it could easily slide around and fit freely on detent case shaft. Fits nicely and moves nicely. No light on that shaft, that tip was so knarly it took a minute to file it smooth( and not touch inside of spring as to not score it while filing tip smooth) so it does not gouge that shaft.

 

[Kevin frazier]

Good night baby

 

[Tripps]

Did you give it a kiss goodnight?

 

[Neville Lush]

Boost up the oil pressure a little while you're in there. Place a .012" shim under the relief valve spring.

 

[Kevin frazier]

Boost up the oil pressure a little while you're in there. Place a .012" shim under the relief valve spring.

thanks for the tip on this, done, that is a feeler gauge shim in there over the washer.

 

[Kevin frazier]

Scavenge pump installed and primed. Bearings installed in bottom case

 

[Kevin frazier]

thanks for the tip on this, done, that is a feeler gauge shim in there over the washer.

redone thank you Neville

 

[Kevin frazier]

Math is amazing, so are rocket engines,