Widowmaker Journey to 200hp, no thats been done. 250hp !

[sonny]

Looking good.

 

[Kevin frazier]

Learnin.

 

[Kevin frazier]

Can i get a tech tip please, hand hold only the sprocket and remove the pressure pump nut. My arse, 30nm.

 

[Kevin frazier]

I have a seal leaking on torsional damper so that will be getting replaced and is there anything else that should be replaced at 65k and its fixing to have alot asked of it, thanks

 

[Kevin frazier]

Ricks stator is holding up well, the coating on the copper windings is gone except for a couple small pieces hanging on, I suspect ill find this stuff, but the copper shows no signs of burning. Ricks

 

[sonny]

I am replacing my stator. With 68,000 it would be my luck to rebuild and then have the stator go south a few thousand later. It has happened before on the harley.

 

[mr hunt]

Can i get a tech tip please, hand hold only the sprocket and

I Just grab both sides of the chain in one hand and undo the nut with a small impact driver

 

[mr hunt]

I am replacing my stator. With 68,000 it would be my luck to rebuild and then have the stator go south a few thousand later. It has happened before on the harley.

Exactly 1 month after the last trans rebuild...did the R/R too

 

[Gerald]

Can i get a tech tip please, hand hold only the sprocket and remove the pressure pump nut. My arse, 30nm.

Use an impact gun, use a couple wooden wedges tight against bottom of chain when torqueing back. Replace the nut before torqueing.

 

[Kevin frazier]

Exactly 1 month after the last trans rebuild...did the R/R too

The coating on copper is burning on oem and charring. But on the Ricks stator it falls off dissapears or melts off i dont know but i do wonder if that keeps wire coils cooler, i dont know but the copper on Ricks is looking good. Time will tell