Vandemon cans and headers.

[dfresh]

Here it is, finally got it all done, went on vacation and then got the flu.

Nice! Are you still planning on the titanium headers?

 

[King Lear]

Here is the full exhaust, heat shields were not on yet. This was the first heat cycle

 

[King Lear]

Nice! Are you still planning on the titanium headers?

Yes, the video is uploading, but here are a few pics. I am installing some carbon fiber parts that will tie in the carbon fiber from the exhaust with the rest of the bike. front fender, rear fender, tire hugger, left engine air intake trim, windshield, drive shaft trim, engine and foot guards. I am keeping the rear fender black, stock radiator trim, and gas cap. I will have some pics this weekend when I get the first round done

 

[dfresh]

Yes, the video is uploading, but here are a few pics. I am installing some carbon fiber parts that will tie in the carbon fiber from the exhaust with the rest of the bike. front fender, rear fender, tire hugger, left engine air intake trim, windshield, drive shaft trim, engine and foot guards. I am keeping the rear fender black, stock radiator trim, and gas cap. I will have some pics this weekend when I get the first round done

It’s looking really sharp!

 

[King Lear]

It’s looking really sharp!

Thanks, the seat and some of the carbon fiber parts come in this week.

 

[sunny]

thats not 2 inch tube, i expect 2 inch tube right out of exhaust port from engine block, thats how i decided not to buy it, not worth my $5000++++ otherwise its nice. I have different requirement

 

[20R3GT]

Yes, the video is uploading, but here are a few pics. I am installing some carbon fiber parts that will tie in the carbon fiber from the exhaust with the rest of the bike. front fender, rear fender, tire hugger, left engine air intake trim, windshield, drive shaft trim, engine and foot guards. I am keeping the rear fender black, stock radiator trim, and gas cap. I will have some pics this weekend when I get the first round done

How it’s ride without tune on full exhaust system? Or did you tune it if so what number did you achieve? Interesting how much hp it will give it over panner tune! And who is tuned?

 

[GTRMIA]

Vandemon rear exhaust on, the Vandemon Titanium headers should be here by 9/16 and I will install them. I have a BT Moto full exhaust tune with DNK air filter. I will post how it goes once I have it installed and done. So far with just the air filter, rear non-evalve exhaust and BT tune on it runs strong, has a little decel pop on occasion, once I get the titanium headers on I will update!

I'm in the market for a Vandemon exhaust upgrade on my '22 GT. Did you get the Stealth E switchable version or the Non-e valve loud only version? I did not see the switch on your bike so I assume the non-switchable?

If so, are you happy with the louder sound all the time or any sense that the switchable would have been preferred (cost aside) for say highway/longer trip riding on the quiet mode?

 

[GTRMIA]

Here it is, finally got it all done, went on vacation and then got the flu. I will post the entire exhaust shortly.

I'm in the market for a Vandemon exhaust upgrade on my '22 GT.

Is your system the standard (not stealth version - don't see the switch in your video). If so, are you happy with the louder sound all the time or any sense that the switchable would have been preferred (cost aside) for say highway/longer trip riding on the quiet mode?