Clutch Rod Is this the right way around?

[warp9.9]

The wavey washer goes on the inside of the thrust face it keeps the lifeter shaft away from the end of the transmission shaft so oil flows thru. it fits loosley and is on all Rockets.

location below

now on the other side of the permanent thrust face is the needle roller bearing. so it has a nice hard surface to run on. then the washer which is the other hard surface for the needle bearing to run on. (sandwiched between) also the thrust washer protect the aluminum surface of the old style pressure plate.
Hope this helps

 

[El Bruto]

I don't know enough to comment...

I know the clutch was fine.. And I kicked the parts on the floor... So now I don't know the order or position, and niether the parts or service manual make it clear...

 

[El Bruto]

Thanks warp... Thats exactly what I needed to know..

So.. Wavy is by itself on inner face...
On other side, the needle bearing, then thrust washer.. So bearing is sandwiched between the "permanent" washer and the loose one.. Which in turn sits inside the clutch face plate... Right?

 

[warp9.9]

Thanks warp... Thats exactly what I needed to know..

So.. Wavy is by itself on inner face...
On other side, the needle bearing, then thrust washer.. So bearing is sandwiched between the "permanent" washer and the loose one.. Which in turn sits inside the clutch face plate... Right?

Yes exactly
Make sure you do not mix up the rear clutch fiber if your using the anti judder spring and seat.