power

Recent contents Top users
  1. Steamer97

    ram air Horse power?

    As far as airbox pressure at under 100 mph speed its nice to imagine it. Other forums I'm on proved it a fallacy long ago. Cool air is worth HP though as many know. My question is there a person who has dyno'd their r3 stock, and with the ram air for a comparison? I searched and didn't find this...
  2. Jvheli

    Want to Buy Power Commander V

    Looking for one stateside if anyone has one for sale.
  3. Hammer

    No Pulsing power to coils

    Hey Guys, Figured I'd move my issue out of the introduction section and hopefully get some more feedback. I picked up the bike not running with really no information on its condition. I figured from the condition it was left in that it has a no spark issue. I reassembled the bike from the...
  4. Al Burdon

    Intermittent Power Fault

    Have had intermittent loss of power but always returned before a resolution was foun While riding on rough dirt I had a complete loss of power. Stopped lifted tank wriggled some wires and keyless start module power returned. Lowered tank power disappeared. Raised tank disconnected keyless...
  5. R-III-R Turbo

    How To: Fit Carpenter Racing 210/240/265hp Kit (Inc. Dialling In Cams)

    Following a few requests from fellow captains recently – not so much of an unofficial “how to”, as it is just a documentation of “how I did it” (took me a solid week the first time) This is in NO WAY a substitute for the expert guidance of Bob Carpenter & his boys. You need to be at least very...

  6. I Need more power

    The bike currently has stock pipes with a decant pipe and that's pretty much it. Using tuneecu I used a map that opens the secondaries and it feels more responsive but not by enough. I'm thinking of a ramair setup and aftermarket pipes when funds allow but eventually I want to supercharge or...
  7. skaarlaj

    Watcha think about this power combo?

    Either of Carpenter racing's full exhaust ram air's intake system (single foam filter) Tuning??? I like the original Carpenters header, and exhaust, however; the equal length header / sidewinder looks good too. I'd really like to do the triple K&N's, but don't want to modify or delete the claw...
  8. Claviger

    Putting Rocket Power in Context

    The below image is a compiled graph of a few different bikes and my recent R3 dyno. Kind of puts it in perspective.. eh? I had to extend the graph just to fit the curves luls.
  9. ArekDeBoss

    Loss of power

    I have 2015 roadster. Purchased it few months ago with a seg of short exhausts. No idea what kind, i know nothing about tunes etc. Getting to the point: I recently noticed that around 3.700 rpm on 3rd 4th and 5th gear I hit power plateau. Engine revs but i lose the pull if you know what im...
  10. Ishrub

    Dynojet POD-300 Digital Displays are on sale at MotoMummy for US$195.

    Dynojet POD-300 Digital Displays are on sale at MotoMummy for US$195. Dynojet POD-300 Digital Display
  11. Allan S

    ** SOLD ** Power commander 5 and Autotune

    Two months ago I installed a new PCV and AT onto my 2017 roadster to perfect my already fantastic map. I have run enough miles now for it to have done its work and I'm taking it off now as it is no longer needed. The cheapest I found this on line was at $521USD from Motomummy..200 dollars less...
  12. RacerX74

    Dyno Graph

    Guys. Take a look at this dyno run graph posted on the social media by a local turner . Power commander and setup on a 2010 Rocket lll . Has it lost to much torque and at the bottom for the sake of more up top
  13. Marcin

    power commander V analog engine temp input

    Anyone have experience with power commander V analog engine temp input, what voltage and temp should be inscribe to software?
  14. Tyler Bonser

    backfire, low power, stalling. previous high idle

    Right to the point 2005 rocket 22,000 miles. Started to get a occasional high idle but would go away after a minute then started rarely getting a backfire when i would be lugging it down a bit then get on the throttle. Problem got worse so took it to a Triumph dealer. Just to point this out...
  15. Drmatt357

    ** SOLD ** DynoJet Power Commander for Rocket PCV NIB

    Never used it. $265 . Includes Shipping Conus
  16. Bedifferent

    For Sale **SOLD** Rowe PDM60 Power Distribution Module

    Hi Guys I have a Rowe Electronics PDM60 that is virtually new. I bought it around 3 weeks ago and installed it on my R3T. I even did a post about the install I did, but have yet to do a updated post as I made some changes to my mount. There is nothing wrong with this PDM60 and everything...
  17. Idaho Red Rocket 3

    Found a Power Commander V and Auto Tuner in bike ?????

    My new to me 2008 Moto Guzzi Breva 1200 Sport has a Mistral exhaust and a cat eliminator pipe. Runs well and sounds really good. Today digging thru the wiring I found a Power Commander V and the accompanying PC Auto Tuner. How do you use and tune these things ?
  18. Quebekers

    help roadster 2017 power commander and autotune

    Hello, come from Québec. Rocket 3 are very rarely in my area. No shop for dyno run. Thank you all, to be there for me. My roadster modification are tors, k&n oem replacement filter, and triumph dealer tune for tors. in future i will buy by pass and ramair but not this year. i just bought pc5 and...
  19. Tony Casey

    Power source options.

    Finally sorted out my power commander v and AT too work together, the problem i was having there was a bad connection on the positive side. I had connected the power wire to my rear brake light, tapping into the wire with the tags supplied by dynajet this gave me insufficient power to power up...
  20. Tony Casey

    Power Commander V with Auto Tune.

    Help needed. I purchase a power commander v and autotune to use on my 2012 Rocket Roadster. With the help from Hanso (thank you once again Hanso for your help) and a few electrical problems solved. i have the bike running well, although have had the coment that the boys can smell unused fuel...
Back
Top