Stepper motor regulation problems

[wzuccarello]

Yes the Triumph starter gear only spins one way with pliers.
I do know to change out the nose of the Toyota starter.
I do suspect a bad TPS.
Thanks for the reply.

I was wrong, Triumph and toyota starter will turn both ways with pliers.

 

[TURBO200R4]

I was wrong, Triumph and toyota starter will turn both ways with pliers.

What I was looking for was that one way was easy and the other way is hard.
I know that the toyota starter is like that way.

 

[wzuccarello]

do you have a manual or do you go online for info
i can help if you don't have

Thanks, I have a genuine Triumph manual.

Yes the Triumph starter gear only spins one way with pliers.
I do know to change out the nose of the Toyota starter.
I do suspect a bad TPS.
Thanks for the reply.

Also had to use the Toyota motor backplat

Thanks guys, all solved!
My problem was that the accelerator throttle didn't reset to the starting point!
And so this staggered the distance then with the stepper motor!
I leave the photos here to understand each other better as I don't know English well and I'm using a translator.

Well lubricated the throttle body and the stepper motor and then reset the tps settings and it returned to move correctly between 0.60 and 0.72!

Made adaptation reset, now the bike is perfect! The minimum drops as from the map!

Thank you all, super kind!

This was exactly my problem! I had to use penetrant and pliers to loosen the idle linkage section on the throttle shaft above the stepper motor. It was stuck and keeping the butterflies from completely closing and also made it impossible to adjust stepper.