Shaft Splines
So what do you think? I don't think they look that bad. In any case its going back together as is with generous honda moly 60.

 
that looks like rust if it is i would clean it up before lubing.
you can move the shaft around and tell if there is any binding on the front ujoint.
i would put it all together and before tightening the axle bolts i would tighten the nuts to the drive shaft tube first.
just looked in manual torque first to 20Nm then to 64Nm.
the manual has a tightening sequence looking at pic should be inside top** out side bottom**inside bottom** outside top.
 
Thanks Turbo, that makes sense to torque the shaft nuts, in sequence, before torquing the axle. It looks like rust but I think it is just the factory dry lube, but i will clean it up before applying the moly 60.
 
You must log in or register to reply here.

Similar threads

Drive Shaft
3 4 5
Replies
42
Views
2K
r3badboy
Lubing the shaft
2
Replies
19
Views
2K
Tripps
Belt or shaft?
2
Replies
17
Views
1K
Torquex2
Drive shaft question
2
Replies
10
Views
3K
bebsy
Drive shaft sleeve?
Replies
9
Views
2K
bebsy
Menu
Log in
Register