Rmoving injectors to clean

Ransom

.060 Over
Joined
Oct 30, 2008
Messages
162
Location
Surprise, Arizona
Due to work and illness my R3T sat for 6 months wit untreated fuel. Now it will start with starting fluid but not idle clean or long. I'm going to pull Injectors to clean them - does anyone know if I have to remove throttle bodies to get to them or is there access with throttle bodies inplace?

Edited for spelling
 
Last edited:
if it were mine I would get all the gas out of the tank then put a couple of good gallons in
then start it with starting fluid and try to keep it running with the fluid will probably run on that old gas once it gets hot.
i would not get to close to throttle bodies if it back fires it will give you a good hair cut lol
 
Add half a bottle of "Cataclean" (one bottle is sufficient for an average car) then fill tank with high-octane super unleaded, the highest octane you can get. This stuff will cleanout the entire fuel system with the use of that one tank of fuel. Run it low, then refill with normal 94 RON 👍😎
 
Give it a good dose of injector cleaner and an Italian tune, it's way more fun than pulling injectors and is mostly like going to fix the issue. That's my philosophy anyway.
 
You may want to drain the tank and replace the fuel filter and inspect the rest of the in tank system.


I ended up rebuilding/replacing the entire in tank system.

bob
 
Back
Top