Redesigned RamAir filter available for ordering

[Mittzy]

My RamAir filter just arrived. While I haven't seen the original base plate in person, the new design looks much improved over the photos I've seen of the original one. The rubber collars are much thicker and they have grooves to match the throttle bodies.

I'm off to Laughlin River Run in a couple of days so the installation report will have to wait, but in the meanwhile, below are a few photos of the new rubber mounts.

Holy Crap!!!! They did the "Not Possible".
I wonder if my input helped them to redesign????

 

[crashpete]

Is it available stateside, or only from the UK?

 

[motolink]

Is there a photo of the new design

 

[CanberraR3]

I've been hanging back from getting the Ramair due to the base plate issues. Only just put a new stock filter in 1000 miles ago.

Being a Scot and liking to get my monies worth I'll wait until her next service and get the ramair installed then

I hear what you're saying but it actually makes no sense at all. The Ramair can be cleaned and re-used so you're not actually saving anything, just postponing the expenditure.

 

[ozrider]

Is there a photo of the new design

Check out post #10, photos are there @motolink

 

[rocketpockets05]

Looking good !

 

[cr0ft]

My RamAir filter just arrived. While I haven't seen the original base plate in person, the new design looks much improved over the photos I've seen of the original one. The rubber collars are much thicker and they have grooves to match the throttle bodies.

That looks fantastic. Guess I can stop vacillating and order one of these immediately, with any luck I can get it on the bike before the 9th of may run I'm going on.

Edit 5 minutes later: placed an order.

Edit 10 minutes later: dammit! I missed the discount code. Put in "10OFF" when ordering and get 10% off. Hope they can apply it retroactively...

 

[cr0ft]

Is it available stateside, or only from the UK?

Shipping worldwide is a thing. They have an online store, http://ramair-filters.co.uk

 

[Scorp]

I would love a later version with heat shields and a rammed air effect

 

[motolink]

Check out post #10, photos are there @motolink

Thank you, the base plate looks great, it looks like a big improvement and should make fitting much easier.