Updated on my oil leak!!!!!
So I can say on my case it was scratched and kind off corroded meeting surfaces between cast podium and cooper washer!
So I did 5-6 time different cooper sizes washers and aluminum with bonded in oring inside and without with and without hondabond HT and noting was helping more than 3-4 weeks And if you don’t pass 3500-4000prm but this bike build not for grandma ride style but full potential 3 seconds to 60
main reason I bought it!!!!
Dealer don’t know nothing and trying to convince me the oil dripping from intake on the bolt!!!!
So I thought it’s last time I try to do something my self before believing in another dealer fairytale story about porosity in casting and brake all bike in to the million pieces and sand transmission cover in magic resin impregnation s#it and all it will cost me left kidney to do it and no 100% it will be fixed !!
So I take triangle file and start filing from inside out one pass after another flip file and constant cleaning till the podium was nice straight and without any dip scratches !!!
After I wrap file with 220 grid sand paper and tape it with painter tape and same technique was doing sanding from inside out and flipped on another side and constant cleaning till surface became mirror and sand paper did not grip any more!!
It take me half day 4-5 hours with light behind me and sitting position on the floor than I spray brake cleaner and put new cooper washer with 2mm thickness small amount Hondabond HD only on washer and tight it down till wrench was spinning and after 30 minutes I take first ride everything was dry after!!
So I was constantly checking every day for leaks last two months and ride it on first gear up to 64 mph all the time!!! So it’s clean and dry and I’m happy I don’t need to sale my rocket
For sure it was bad turning process on factory they cutting aluminum case with too higher speed and chips from aluminum was falling down under the cutter and was mangled surface under the cutter!! If the cutter feed was slower then aluminum shavings will be one long curling pice which was falling down from working table and surface was mirror clean all rocket owners newer now this problem!!!
First picture shows bad surface before I did sanding and filing and another two one month different between!!! Don’t believe in dealer traps and try to do it before and only after it still leaks take a bike a part!! If you going to do it tape with painter tape all black parts around before processing to filing!!! Easy way to do it is probably to take intake off !!! Good luck for all you guys!!!!
