How do I find ISCV nut?
vocaldog said:
That's just what I was looking for. Thanks so much. Looks like it's going to be hard to get the gapper up in there! Wish me luck!
Click to expand...
Its really not bad with a decent feeler gauge

When you lube the stepper motor shaft get the WD40 straw under the rubber boot.



Then you can do the stepper motor test to cycle the shaft a some times to loosen her up.
 
warp9.9 said:
Its really not bad with a decent feeler gauge

When you lube the stepper motor shaft get the WD40 straw under the rubber boot.



Then you can do the stepper motor test to cycle the shaft a some times to loosen her up.
Click to expand...
Thank you!
 
Has anyone tried soldering wire tails to the coils then using good quality crimp connectors - this would illuminate any vibration causing the connectors coming loose over time
 
Mittzy said:
Has anyone tried soldering wire tails to the coils then using good quality crimp connectors - this would illuminate any vibration causing the connectors coming loose over time
Click to expand...
Yes that could be done. I re-crimped mine and have never had them come loose again. It makes me wonder if the original crimp was or is just a tad bit shy of being tight. Time will tell By then I hope to find out if the stick coils say out of a sprint st would work and if it would be better functional wise.
 
You must log in or register to reply here.

Similar threads

How to flash map using TuneEcu?
Replies
0
Views
262
Grizli784
Not how I remember
Replies
8
Views
636
Dr.D
Consensus about to which gears i1 i2 i3 do correspond?
Replies
0
Views
310
Lost Soul
Does this mean my R3R is tuned ?
Replies
6
Views
443
R3Rblkshdw
Download TuneECU for Windows (versions 2.5.5 & 2.5.8)
2
Replies
11
Views
5K
firemanjim911
Menu
Log in
Register