Hot front brakes

TURBO200R4 said:

if the lever does not have free play the brake will not release.

also
if u down shift like into 1st or 2nd and u just let the clutch lever out fast it will slide the rear tire and it always seems to slide out back tire going to the left.
ran over a tennis ball size rock and what happens is your arm goes down and the rpms goes to about 3000 rpms which makes the bike do a right turn. i was in sand and done that and the bike did a 180 and i was heading back the way i had come .

Click to expand...

Kevin frazier said:

This is where a slipper clutch would help

Click to expand...

Patto said:

Hi everyone I have a problem and looking for ideas why , the front brakes disks are too hot to touch the right hand side disk even more after a short ride and gentle braking to a stop . I tought I had a sticking calliper so got a rebuild kit and fitted new seals and pistons to both callipers . Just been for a 5 min ride and same problems again, is there a valve or possible proble with master cylinder that could cause the problem

Click to expand...

Patto said:

When pulling the brake And releasing the wheel will spin again , it rotates about 1 Wheel revolution , on a side note since bleeding the brakes when The lever is first pulled it fells soft then if you pull it a couple of times it will harden up , is there a technique to the rocket or do I need to activate the abs as well

Click to expand...

bebsy said:

If once bled and solid and a short time later feels spongy providing all the air is expelled, would most definatley be the piston seal in the master cylinder, cheap easy fix, if you have gone to all the trouble of refurbishing the calipers mays well go the distance

Click to expand...

TURBO200R4 said:

rocketeer4life lets not make that to soon

Click to expand...