Clear Indicators
Thats some fine lookin work there Nusse.
Any more examples of what you have done or could do?
How about a clear Rocket tail light lens?
Now don't run out and make one just cause I asked about it,
but if you've already done it and have pictures,
I'd sure like to see it.
Again, Good work and nicely done.
 
Thanks!

I just crashed my bike, so I have plans to make quit a lot of parts during the winter. Only got a carbon fiber fork sheild ready so far.

This week I will do some trials with red lences for those who like to use them as position lights. Hopefully I will get time as well to try to make a smoke lence that don't steal too much light.

Within a month or two I will also have a flat lence ready.

A clear tail light is no problem to make. It would take some 70 - 80 EUR worth on silikon to make the mould, and then some EUR 20 for the material to cast it. The only problem is that the tail light is so thick, that you might be able to see a grey/yellowish tone in the glas. Can't say for sure untill one is made.
 
Mike5100:

It takes 48h to make one, so I'm not very fast. At the moment I could send a set of 4 within about 2 weeks, if I don't have to scrap to many.

Orange bulbs are not too hard to get hold of and I also heard that you could just paint the bulb orange.

I can give you a few links to where to buy them. I recomend that you get the ones with a silver top for maximum stealth.
 
You must log in or register to reply here.

Similar threads

Turn Signals - Indicators - Blinkers
2
Replies
18
Views
786
Fred F.
Clear lens for Blinkers?
Replies
7
Views
679
redrocket
Clearview R3T screens......(in case you didn't notice)
Replies
1
Views
436
crazyman
Clearview Windscreen
2
Replies
13
Views
676
Navigator
Clearview windscreen
2 3
Replies
20
Views
1K
rlittle
Menu
Log in
Register