What did you do to your Rocket today?

[Boog]

Updated Brahma's embellisher. A workmate printed this off in black and red plastic but the finished product was more charcoal and maroon. So, I broke out my testers model paint and changed it to my liking.
Lessons learned on this one is, I think it is too thin. I broke it when drilling the screw holes and used super glue to repair. A strip of duct tape reinforces the back side

 

[phar2slo]

Took it out to a cafe. With the Triumph Riders Group. Nice day to for the middle of winter.

 

[sonny]

I need to clean up the crank case breather and tighten up one of the forward foot pegs. Then a good wash and wax.

 

[Boog]

Went to Bikes and Breakfast in Clifton, VA with Ed this morning.
Great turnout, lots of cool bikes to see.

 

[Kevin frazier]

I need to clean up the crank case breather and tighten up one of the forward foot pegs. Then a good wash and wax.

Done yet?

 

[Kevin frazier]

Went to Bikes and Breakfast in Clifton, VA with Ed this morning.
Great turnout, lots of cool bikes to see.

Cool cars too

 

[Kevin frazier]

Updated Brahma's embellisher. A workmate printed this off in black and red plastic but the finished product was more charcoal and maroon. So, I broke out my testers model paint and changed it to my liking.
Lessons learned on this one is, I think it is too thin. I broke it when drilling the screw holes and used super glue to repair. A strip of duct tape reinforces the back side

Hey lets get that boot up on that stepper motor, we know how rough you are on stepper motors, tighten up boog

 

[RocketEd]

Rode it around 190 miles going out to make sure the Pacific is still there.
Highlight of the ride was getting the sweepers on 101 north of Raymond to myself, which almost never happens.

 

[tribal]

Recent Tribal work:
Removed broken Triumph plate light.
Removed broken Kellermann rear LED blinkers after a 13 year run.
Cleaned up broken wires, old tape & zip ties.
Installed 2 Kuryakyn - LED License Plate Bolt Lights
Installed Kuryakyn by Kellermann Bullet 1000 Collection, LED Turn Signals plus Running HALO plus Brake lights.
Installed new front LED fog/driving lights on tip over bars.
Installed new Triumph windshield (that I had traded Rivco Running boards for with Ishrub) OVER the smaller tribal fly screen after drilling two holes in its bracket to prevent
the acorn nut in the center of the windshield from rubbing. There is about a 1" gap to give room to lower the clear screen a bit if needed.
Working on Fuse Block, trailer wiring and brake controller wiring.

 

[tribal]

Yesterday I worked on Black Mamba too as I have to show love to both bikes so they don't get jealous:
Installed Rivco Chrome drive shaft cover that I had traded Ishrub my backrest and pad for.
Installed matching Rivco Chrome swing arm cover bling that I found on eBay for $60.