Well Sh!t...

[EasTexRIII]

So the Ramair should be here any day and these were just located

That shouldn't be hard to sell on here - But you'll like the RamAir setup better I think

 

[WyldCFH]

That shouldn't be hard to sell on here - But you'll like the RamAir setup better I think

I haven't decided which one I want now. Ozrider has some personal things going on and not currently making the ozclaw which I was going to use with the ramair.

But with no claw, I'd rather the K&N since I think they look better and a few HP either way is not a big deal

 

[EasTexRIII]

I haven't decided which one I want now. Ozrider has some personal things going on and not currently making the ozclaw which I was going to use with the ramair.

But with no claw, I'd rather the K&N since I think they look better and a few HP either way is not a big deal

You don't need an Ozclaw - you need a thin wheel grinding tool and a strip of door edge protector

 

[WyldCFH]

You don't need an Ozclaw - you need a thin wheel grinding tool

I don't like the claw at all. Mine has been off with the stock airbox for almost a year. I like the ozclaw because it pulls fresh air from the front of the bike. Otherwise I prefer without a claw.

 

[Paul Bryant]

You don't need an Ozclaw - you need a thin wheel grinding tool and a strip of door edge protector

Hey is that you Clint ? looks different to your avatar

 

[albertaduke]

Should I ask how you lost them?...No I wont then..
The Ramair will fit under the factory bearclaw albeit a bit snug and comes with the breather filter you need. Not sure about the Ozclaw...maybe someone else can help there. The breather filter is difficult to get in there if your fingers imitate sausages. The wee "s"shaped hose in there can be cut in half and then put back on the fitting and the breather can then be put on the end of that...its an easier fit then.
There is a hole and "o" ring for the AIT sensor in the Ramair box itself which places the sensor in the correct locality to measure the air temp that enters the throttle bodies...most important for the tune.
A detailed fitting video on YouTube is a real help. You can watch it all the way thru to get the gist then play it again pausing it as you complete each step. Do the task as he does including the cloth in the throttle bodies to avoid dropping anything down the throats...
Good luck and enjoy....youre gonna love the clatter of those secondaries when you twist the throttle!
Oh and a P.S.!....Do not over tighten the hose clamps on the throttle bodies as they WILL break the thin rubber boots...I think 5nm is recommended from memory....if you don't have a torque wrench, then its "5 NOT MUCH"....just firm so they don't come off easily.

and put a tie wrap in the middle across the body slighly snug so you do not loose the ramair...

 

[breeze]

I haven't decided which one I want now. Ozrider has some personal things going on and not currently making the ozclaw which I was going to use with the ramair.

But with no claw, I'd rather the K&N since I think they look better and a few HP either way is not a big deal

if that ram air will fit my 07 and you dont want it i will compensate you for it

 

[Ygransom]

So the Ramair should be here any day and these were just located

Now you need another R3 to mount those on.

 

[Steel]

if that ram air will fit my 07 and you dont want it i will compensate you for it

Or you can sell him your Ozclaw.

 

[EasTexRIII]

Hey is that you Clint ? looks different to your avatar

Ya, I'm MUCH purtier in person!