Should I ask how you lost them?...No I wont then..
The Ramair will fit under the factory bearclaw albeit a bit snug and comes with the breather filter you need. Not sure about the Ozclaw...maybe someone else can help there. The breather filter is difficult to get in there if your fingers imitate sausages. The wee "s"shaped hose in there can be cut in half and then put back on the fitting and the breather can then be put on the end of that...its an easier fit then.
There is a hole and "o" ring for the AIT sensor in the Ramair box itself which places the sensor in the correct locality to measure the air temp that enters the throttle bodies...most important for the tune.
A detailed fitting video on YouTube is a real help. You can watch it all the way thru to get the gist then play it again pausing it as you complete each step. Do the task as he does including the cloth in the throttle bodies to avoid dropping anything down the throats...
Good luck and enjoy....youre gonna love the clatter of those secondaries when you twist the throttle!
Oh and a P.S.!....Do not over tighten the hose clamps on the throttle bodies as they WILL break the thin rubber boots...I think 5nm is recommended from memory....if you don't have a torque wrench, then its "5 NOT MUCH"....just firm so they don't come off easily.