TuneECU

checked that and youre right it seems....why is the tune not being picked up by tuneecu?...something im doing wrong here...
 
Couple of things...Yes the cruise control still works after the tune download...
and this is the dyno chart done today...

Couple of things...Yes the cruise control still works after the tune download...
and this is the dyno chart done today...
183 Nm torque is about what you get with ETV1 (rain) tables...
 
So On a TFC once you reprogram map 31025, the cruse control and TPMS will function normally?
 
...this morning i went back in this thread and found the photos of the two maps...the stock one and the altered one. I compared my tables and found what i was looking for....loaded the map and sent it to the bike. Took maybe 20 mins. Ran the bike on idle for 20 mins then took it for a test. I wont know for absolute sure what the increase is till i dyno it again but insanity has crept in!!
 
183 Nm torque is about what you get with ETV1 (rain) tables...
...thats the stock map Penner...i did alter my exhaust...removed the cat so dont know if that has made a difference?..maybe?..its showing around 150hp at the back wheel so thats a gain from stock i think...
 
...thats the stock map Penner...i did alter my exhaust...removed the cat so dont know if that has made a difference?..maybe?..its showing around 150hp at the back wheel so thats a gain from stock i think...
I got about 145 hp and a little over 200 Nm at rear wheel with the stock map. Maybe you are right and the exhaust caused that. Will you dyno it with an unrestricted map later?