T1292006 Sensor, Pressure, Airbox - What doe it do?

[ruzzle]

Well let me see if I can say this without putting my foot in my mouth.

The map sensor is the one with the three vacuum hoses that go to the throttle bodies the sensor in the air box where the are original air filter sets is the (ats) air temperature sensor it measures the air temp going into the throttle bodies and the ecu uses that info when setting fuel ratio.
if this sensor gets to close to a real hot surface it will through off the fuel ratio.

Air pressure, not temp. (Tho pressure will vary with temp.) The Intake Air Temp. Sensor in the intake plumbing does the temp.

 

[TURBO200R4]

Air pressure, not temp. (Tho pressure will vary with temp.) The Intake Air Temp. Sensor in the intake plumbing does the temp.

Just was not sure which u were referring to until u mention vacuum hoses.

 

[TURBO200R4]

On most cars and trucks
The map sensor with key on engine off is the baromic sensor. If the reading is off very much then u have a bad map sensor.

 

[Starmanut]

Excellent idea. I am about to start into my Ramair install soon. Sure would like to see a picture of where you mounted it, insulated from engine heat.
Thanks,
Dean

With RamAir you are probably only going to have to worry about the relocation of the Intake Air Temperature sensor

If you buy the kit, you will get an extension wire that plugs into where the sensor is and there is a hole in the plate with the filters that the sensor goes in.
The instructions in the kit are very comprehensive with plenty of pictures.
Easy Peasy!!

 

[tribal]

Lots-o-sensors.

14 Kit, Gear Position Sensor T1296589
16 Sensor, Crankshaft Position T1290118
18 Sensor, O2, Heated T2201247
19 Sensor, Pressure, Airbox T1292006
23 Sensor, Temperature T1290360
24 Air Pressure Sensor T1292015
26 Sensor, Air Temperature T1292004
29 Road Speed Sensor T1290053

Sensors or switches not shown here:
Throttle Position, SE (Primary) T1245113
Throttle Position sensor, secondary T1245010
Clutch lever sensor which is part of Switch Set, LH T2046018
Kickstand Switch T2080681
Switch & Banjo Bolt, Oil Press. T1210504
Fuel Level Sender T1241089 or Kit T1241190 - not used by ECU, just gauge cluster
Switch, Fall Detection T2502405 - cuts engine but not used by ECU
Thermostat T2100715 - I don't think it is used directly by the ECU i.e. no water temperature sensor

Did I get them all??

 

[wjb]

You make it sound like our bikes are very, sensitive.