Rocket science

[BigKel]

The pipes should leave Brissy today so if its a wet weekend my old pipes will be coming off the bike.
After I get my hot little hands on them it should take 20 mins to fit them and then I will book it in for a dyno tune.

 

[Bat]

it will take more than twenty minutes as one of the threads said have to stop and admire lol after you dyno the pipe will fade a little bit but normal chrome polish will bring it back like new

 

[BigKel]

it will take more than twenty minutes as one of the threads said have to stop and admire lol after you dyno the pipe will fade a little bit but normal chrome polish will bring it back like new

20 mins is allowing 5 min to stop and look at them

 

[1olbull]

As this was brewing I finally found the dyno posted of stock vs Ramair setup on the same bike. Showed 20hp gain peak and a healthy gain across the board. Guess I am doing I+E instead of just E

Yessiree!
That I & E are a lot like sex.
One is like sex with keeping your clothes on and both are like sex being nekkid!!!!

 

[ozrider]

it will take more than twenty minutes as one of the threads said have to stop and admire lol after you dyno the pipe will fade a little bit but normal chrome polish will bring it back like new

make sure they put a good fan blowing air on the headers when they dyno and they should be fine.......

 

[Bat]

cant pick my bike up until saturday morning from the dyno due to work but have the figures with the ces pipes 169.89 rwhp.....166.77 ftlbs bloody so close to 170 might have to buy the new german plugs out will give an extra 2.2 hp

 

[1olbull]

cant pick my bike up until saturday morning from the dyno due to work but have the figures with the ces pipes 169.89 rwhp.....166.77 ftlbs bloody so close to 170 might have to buy the new german plugs out will give an extra 2.2 hp

Is this with a stock engine???

 

[BigKel]

cant pick my bike up until saturday morning from the dyno due to work but have the figures with the ces pipes 169.89 rwhp.....166.77 ftlbs bloody so close to 170 might have to buy the new german plugs out will give an extra 2.2 hp

That's some nice numbers, What sort of air filters are you running?

 

[CanberraR3]

As this was brewing I finally found the dyno posted of stock vs Ramair setup on the same bike. Showed 20hp gain peak and a healthy gain across the board. Guess I am doing I+E instead of just E

As I recall, there was also the small matter of a Neville Lush tune that contributed to that gain - I'd suggest almost all of it. It might have been the same bike but the filter wasn't the only thing changed.

 

[bruce aussie]

cant pick my bike up until saturday morning from the dyno due to work but have the figures with the ces pipes 169.89 rwhp.....166.77 ftlbs bloody so close to 170 might have to buy the new german plugs out will give an extra 2.2 hp

The 2-1/4 inch baffle certainly gives 5 or 6 more hp and torque than the 2 inch. That's the second one I've seen Dynoed by Fred with similar figures.