Rocket science

The pipes should leave Brissy today so if its a wet weekend my old pipes will be coming off the bike.
After I get my hot little hands on them it should take 20 mins to fit them and then I will book it in for a dyno tune.
 
it will take more than twenty minutes as one of the threads said have to stop and admire lol after you dyno the pipe will fade a little bit but normal chrome polish will bring it back like new
 
Bat said:
it will take more than twenty minutes as one of the threads said have to stop and admire lol after you dyno the pipe will fade a little bit but normal chrome polish will bring it back like new
Click to expand...
20 mins is allowing 5 min to stop and look at them
 
Claviger said:
As this was brewing I finally found the dyno posted of stock vs Ramair setup on the same bike. Showed 20hp gain peak and a healthy gain across the board. Guess I am doing I+E instead of just E
Click to expand...

Yessiree!
That I & E are a lot like sex.
One is like sex with keeping your clothes on and both are like sex being nekkid!!!!
 
Bat said:
it will take more than twenty minutes as one of the threads said have to stop and admire lol after you dyno the pipe will fade a little bit but normal chrome polish will bring it back like new
Click to expand...

make sure they put a good fan blowing air on the headers when they dyno and they should be fine.......
 
cant pick my bike up until saturday morning from the dyno due to work but have the figures with the ces pipes 169.89 rwhp.....166.77 ftlbs bloody so close to 170 might have to buy the new german plugs out will give an extra 2.2 hp
 
Bat said:
cant pick my bike up until saturday morning from the dyno due to work but have the figures with the ces pipes 169.89 rwhp.....166.77 ftlbs bloody so close to 170 might have to buy the new german plugs out will give an extra 2.2 hp
Click to expand...

Is this with a stock engine???
 
Bat said:
cant pick my bike up until saturday morning from the dyno due to work but have the figures with the ces pipes 169.89 rwhp.....166.77 ftlbs bloody so close to 170 might have to buy the new german plugs out will give an extra 2.2 hp
Click to expand...
That's some nice numbers, What sort of air filters are you running?
 
Claviger said:
As this was brewing I finally found the dyno posted of stock vs Ramair setup on the same bike. Showed 20hp gain peak and a healthy gain across the board. Guess I am doing I+E instead of just E
Click to expand...

As I recall, there was also the small matter of a Neville Lush tune that contributed to that gain - I'd suggest almost all of it. It might have been the same bike but the filter wasn't the only thing changed.
 
Bat said:
cant pick my bike up until saturday morning from the dyno due to work but have the figures with the ces pipes 169.89 rwhp.....166.77 ftlbs bloody so close to 170 might have to buy the new german plugs out will give an extra 2.2 hp
Click to expand...
The 2-1/4 inch baffle certainly gives 5 or 6 more hp and torque than the 2 inch. That's the second one I've seen Dynoed by Fred with similar figures.
 
You must log in or register to reply here.

Similar threads

Asking price for a 2015 Rocket X here in Perth, Australia.
Replies
2
Views
203
Gromett
Recommended Rocket iii workshops in SEQ.
Replies
2
Views
274
Blocka
Recommended Rocket iii workshops in SEQ.
Replies
8
Views
414
Pete
TTS PUSH THE BOUNDARIES OF THE SUPERCHARGED ROCKET 3
Replies
5
Views
1K
Journeyman
Red rocket R sighting in beenleigh qld
Replies
0
Views
523
Evil Mitch
Menu
Log in
Register