Radiator leak
OK, my intention is to try a further bodge on the dying one first, I was talking about this to a friend who recommended I try this stuff because it works underwater it will not be affected by the dampness of a fitted and full radiator thats not up to pressure while its curing. I checked the data sheet and its working temperature is -40C to +120C ….. anyone know what temp the rad should be getting to?

 
Don't forget most epoxies and glues want a clean surface to work properly and anti-freeze will contaminate the area.
 
There are some very talented aluminium welders out there that may be able to repair this - trick is finding them
 
I wouldn't trust that stuff to hold up for long , especially with antifreeze in the mix . The Chinese radiator will be fine and a useful stop gap whilst getting yours professionally repaired . Good luck with it all .
 
Mittzy said:
There are some very talented aluminium welders out there that may be able to repair this - trick is finding them
Click to expand...

Take a look at this. Aluminium brazing rods with a gas torch. I repaired an aluminium radiator core with it 4 months ago and it's still water and antifreeze tight. If you can solder you can use this product. Brilliant stuff.
Repair Alum Radiator with BRAZING DURAFIX rods

 
Must be very careful with aluminium as too much heat will result in a whole lot melting away without much notice.
 
good choi
 
You must log in or register to reply here.

Similar threads

Fuel line leak.
Replies
0
Views
374
mjdula
Oil Leak on 08 R3 Touring
2
Replies
12
Views
2K
Gregger
Front brake reservoir leak on new Rocket 3
Replies
4
Views
1K
Eroy
Leaking fuel..
Replies
8
Views
913
Forrest
1600 km forks leaking !!
2
Replies
16
Views
2K
Moogus
Menu
Log in
Register