Ishrub
That's my name ....built like a truck
- Joined
- Feb 18, 2016
- Messages
- 8,940
- Location
- Duffy, Canberra, ACT, AUSTRALIA
- Ride
- 2x2010 ABS Roadsters, Sprint ST 1050 ABS, 3x250s
"Build a bridge" as they say!
Mate you thought you would get the headers, cross pipe and cans for the price I LISTED and sold the headers for to a member I had never met before!
Ask him if yourself if you like. @ChrisACT
Ah facts
Conversations - i should make them open to all in future so I can add everyone with ease!
@dave64 If I missed anything relevant below please advise. I have used BOLD on what I believe is relevant.
It is not yours until an agreed price has been agreed and paid mate!
CES
dave64, Mar 14, 2018
mate are you looking at selling your other set ?
Ishrub, Mar 14, 2018
Yep, "you are so perceptive", as Steve 1oldbull said to me recently.
What do you have at the moment?
I have a silver ceramic CES with 2 black ceramic heat shields that cost $1600 just for the header and has been on about 8000 Kms. I have a stainless (I think) high flow cross pipe and unknown high flow short slash cut twin exhaust cans similar to, but not the same as Pratt shorties. Mine are set up with an even slash cut angle on each side!
But they do stop before rear axle and use std R3 Roadster heat shields at rear and at crossover with a muffler clamp near the collector.
Easily good for 155 -160 RWHP with a HansO tune and RamAir etc. Maybe 165 RWHP with a Dyno tune.
Haven't advertised yet but strangely enough will be seeking Au $1300 + postage all up. From what I have seen a Platt twin and crossover system alone is that sort of cash or more.
******
Later in reply to interest expressed
********
Ishrub, Mar 14, 2018
Canberra mate, will wait till I have fitted the new ones and taken off the old to take photos and post but I shall give you a heads up when i do.
*******
More extensive posts about photos etc etc.
********
dave64, Mar 16, 2018
Do you have a rough idea when this system will be available?
Ishrub, Mar 16, 2018
No not really and I may split it, with the low restriction cross pipe and cans sold separate to the CES Headers with an option to buy both. I see that the dual pipe and cross pipe are more widely used and cost a lot more than just a single can back from header.
dave64, Mar 16, 2018
Ok can I have first dibs on the CES headers please ? We can discuss price of whole system when your ready to go .
Ishrub, Mar 16, 2018
OK I'll post you have first interest when I list them.
dave64, Mar 16, 2018
Thanks mate
dave64, Mar 23, 2018
Any ideas on when your going to be selling the CES headers ?
Ishrub, Mar 24, 2018
They have arrived, I may get it done next week - do not wait on me, as I shall do at my convenience.
I am thinking of listing at $1200 for the CES headers alone as they cost me $1600 + freight. If that shocks you, so be it, I hope to recoup as much as I can.
March 25th
**SOLD** CES take #3
Post#4
Post #6 @ChrisACT - If dave64 doesn't want them, I might be interested.
Post #10 @dave64 - Sell them to Chris mate , he obviously wants them and easier sale . I’ll may go a new set .
**************************
Case closed - I'm done.
Last edited:
