I want to install LED turn signals on my 2016 Roadster. I dont know if I need to install a load resistor and if so what size ( resistance ) to buy or a replacement relay ( I dont know what the difference is but I found a post about it). If I am only replacing the front ones and leaving the rear bulbs stock do I need to do this and if so what to do?
Before I go tearing into something and maybe breaking it , would a Captain mind explaining how the turn signals (or indicators) come apart to execute the "wire switch" for non-functioning LED's? Or does it get done in the mini-harness up by the ECU?
As always, thanks in advance for the wealth of advice available here!
Before I go tearing into something and maybe breaking it , would a Captain mind explaining how the turn signals (or indicators) come apart to execute the "wire switch" for non-functioning LED's? Or does it get done in the mini-harness up by the ECU?
As always, thanks in advance for the wealth of advice available here!
Once you have removed the lens (noting the screws are different each side) you need to place a small screw driver in the slots and rotate the inside reflector fitting to release it and access the wires.