hp/torque mods and dyno sheets

My secondaries were supposedly already open at the top end (using TuneEcu) but the knee was still there. Anyway, after handing my Rocket over to our regional tuning kaiser, the knee was gone.
So I am not really sure, maybe I didn't get it quite right with TuneEcu on the first hand.
 
Good info. I have a tuneecu cable, but have never hooked it up yet. I bought an auto tune also, which isn't on the Rocket yet either. My plan was to open the secondaries at the top end and anywhere else they are closed, except the bottom end of first, as I don't like too much drama at parking lot speeds. Debating about a crossover, a crossover plus CES headers, CES full exhaust, or a Carpenter pipe. The RX-4040's also look interesting. Then I would get it re-dyno'd in the end.
 
This was the latest run. The blue lines were with TORS and the de-restricting tune for the R3T and then tweaked on the dyno.

The red line is same tuner and same dyno from a year later after I put on the RamAir.

I was very happy with the gains made from the RamAir for the money and time involved.

About the only other thing I will do is get a header for it one of these days because after that the days of making power cheaply will be over. ;)

bob

scan0001 (2).jpg
Hi bob I just put your tune on my 2008 touring with d and d pipes and ram air, can’t wait to ride this weekend.
 
Back
Top