Fitting front fender chrome bling R3T

Griff

n + 1
Joined
Nov 5, 2019
Messages
69
Location
Leigh, New Zealand
Ride
2015 R3T, 2018 Indian Roadmaster, 1981 GS1000G
Bought this from a wrecker - off a 2008 model. Anyone advise how these are actually mounted? Particularly the plastic trim pieces? (Obviously the end at the forks is straight forward but at the front end?) TIA
1590971739836.png
 
So there's one approach you might use.

Go to a parts seller - such as Hermy's - and find the part -- no matter that it is no longer available -- copy the part number.

Then find the site for Triumph instructions, enter the part number, and you'll be able to download the PDF.

I've purchased several parts over time that were available for the 2008 model, and install them on my 2014, and did so in each case following this path.

Good luck.
 
So there's one approach you might use.

Go to a parts seller - such as Hermy's - and find the part -- no matter that it is no longer available -- copy the part number.

Then find the site for Triumph instructions, enter the part number, and you'll be able to download the PDF.

I've purchased several parts over time that were available for the 2008 model, and install them on my 2014, and did so in each case following this path.

Good luck.
Thanks Paul! Appreciated.
 
Hi Griff,. You didn't happen to buy that of BJ? If so I have the front brake calipers from that bike.
Aye - that I did Phar2slo. Karen's been nice to deal with. Got the old windshield mount also - am going to see if I can fabricate a QR system for my batwing. Cheers G
 
Back
Top