Bike wont start

[Gutterman]

Hi guys, I have finished fitting some new dinali lights and a Denali horn over the last few days, today when I went to start the bike , all lights up and display seems ok although a spanner image is there (see pic) for some reason the indicators don’t work and no power to starter , no click or anything . I have checked fuses and they are ok, any ideas ? Tia

 

[TURBO200R4]

Was u pulling the clutch in while trying to start

 

[Gutterman]

Was u pulling the clutch in while trying to start

Yes

 

[Mighty Mouse]

Maybe disconnect the battery cables and reconnect and tighten. Kind of a reset thing. Worth a try I would think.

 

[Gutterman]

Maybe disconnect the battery cables and reconnect and tighten. Kind of a reset thing. Worth a try I would think.

Thank's for the reply, I kinda have done that as i always disconnect battery when working on electrics

 

[TURBO200R4]

I seen one post about a guy that did not have his key/fob not close enough because of low bat in fob.
How many miles is on bike?
There is a lot of info on the older bikes i know i have not studied the diagrams on the 2020 up so am at a lose to help much..
On the old ones u can work the clutch while holding the botton.

 

[Gutterman]

I seen one post about a guy that did not have his key/fob not close enough because of low bat in fob.
How many miles is on bike?
There is a lot of info on the older bikes i know i have not studied the diagrams on the 2020 up so am at a lose to help much..
On the old ones u can work the clutch while holding the botton.

Bike done 2000 miles, I put a new battery in fob so I know that’s ok, it just seems odd that all other electrics work pump screen - headlights -horn etc but no indicators - Hazard lights - dead starter button . Baffling

 

[maurice]

Do you hear the pump when hitting toggle switch down?

 

[Gutterman]

Do you hear the pump when hitting toggle switch down?

Yes as I stated before pump works

 

[Gutterman]

Hi guys, I have finished fitting some new dinali lights and a Denali horn over the last few days, today when I went to start the bike , all lights up and display seems ok although a spanner image is there (see pic) for some reason the indicators don’t work and no power to starter , no click or anything . I have checked fuses and they are ok, any ideas ? Tia

Problem found for some blizzard reason the clutch switch had dropped just a mm or so our if it’s home see image