3 K&N ,TORS, No Cat

[jetbuilder]

I've got an 06 R3 with TORS and Cat. removed. I would like to add triple K&N's if some one can sujest a map for this set up I would be greatful.

 

[fat frank]

Are you using Tuneboy? Or, are you looking for a generic Triumph tune?

 

[jetbuilder]

looking for a tune that can be loaded via ECU source

 

[rob o]

there is a tune on the tune ECU web site if you have a R3 not the clasic or roadster

 

[Lester532]

there is a tune on the tune ECU web site if you have a R3 not the clasic or roadster

Which one are you talking about?

There's one for TORs ,Cat delete, and the under seat filter.

I don't see one for pod filters.

 

[rob o]

the one from Trip comes with a warning
the bike it was tuned on was running too ritch to start with

open some of the tunes and compare them they mostly use the same map (witch i belive is too lean for 100% open secondarys if an open exaust is used

the 20145 is the only properly done tune and it's for 3KN's

i tried both and the 20145 is too ritch for my setup and any with the std table and 100% sec are too lean

i will wait untill the corect one shows up

i have u/s kn, cat del, tor, and currently the 226 tune witch is good ritchness
but would love to have the 100%sec

i may buy the 3kn and have done but i dont want to cut the bear claw , we'll see

 

[HellFire]

You don't have to modify the bear claw at all with K&N RU2780's.