install

Recent contents Top users
  1. bebsy

    444 pro install issue

    After installing the 444 rear shock and tightning it up slightly the pressure spreads the plastic bush inside which becomes bigger than the backing washer making it unpleasent to torque it up..anybody had this issue or is it me:ninja:
  2. Allan S

    LED turn signal install advice please?

    I want to install LED turn signals on my 2016 Roadster. I dont know if I need to install a load resistor and if so what size ( resistance ) to buy or a replacement relay ( I dont know what the difference is but I found a post about it). If I am only replacing the front ones and leaving the rear...
  3. Babarocket3newbie

    Ramair and Arnott Air Ride install

    Hey guys, So finally got around to installing the Ramair kit and Arnott air ride. So, just followed this youtube video and install took about an hour and it was a fairly easy install. After install, used Tune ECU and a @HansO (master guru) tune and did the 12 minute tune... OMG let me just...
  4. patrol21

    13 inch progressive install

    Just picked up a set of progressive 13 inch springs. Issue is they are approx 1/4 inch too long to install even with the bike jacked up and rear assembly extended...any cute tricks to compress the ****ing spring/shock has vice grips didn't do jack ****...bloody mess
  5. mexican

    Engine guard install,, heeelp!!

    I started to install the engine guards or crash bars, left side went smooth, right side a big pain, there is a bolt that holds the engine but it just spins, looks like there is a nut behind it somewhere but cant see it, has anybody taken that bolt off and how??
  6. Frosty Rider

    did i install my maps correctly?

    i received maps for the ECU and the PCV, the PCV map seemed pretty straight forward to upload, i'm not sure about the ECU map, I connected and had the TUNEECU software read the current map and then i saved it, Then i went to FILE-OPEN and opened the map i was sent from HANSO then i went to ECU-...
  7. 3Katz

    Help needed with Ramair install

    I read all about the great instructions you get with the Ramair but my kit didn't have any! The process was easy enough after watching a really great video on youtube but it kind of glossed over the part about fitting the IAT sensor to the Ramair base. I can't see how this tiny little rubber...
  8. ricochet

    I want to install these handguards, would they fit the Rocket III?

    Found these handguards from another forum I frequent, these look really cool and they have an adjustable LED light that can be angled and wired as headlights or indicators. Does anyone know if this kind of installation is possible with our bar ends? Acerbis Vision Handguards - Cycle Gear
  9. JSHRAM

    Install Stebel Nautilus air horn how to (another one)

    While I was doing my switch relocate I took advantage of the disassembly to install a Stebel (which I do on all my motorcycles) as I like to see cagers pee their pants when they get too close because they are texting and driving... The stock horn is about as wimpy as it gets. A bike like this...
Back
Top