What did you do to your Rocket today?


I have not tried that product. Gota check it out. Thank you. You are redefining Iron Butt bro.
 
tribal said:
Yepper, a porta-potty.
Sadly, i have ****canned the ****ter as it was too bulky and heavy for my rig.

Too bad as i put a lot of effort into customizing it and used up all my decals...
Click to expand...
.... and don't forget that gold vinyl top wrap...every crease, crevice, 'foldover' and 'fallshort'.

You need the modern campers version, or make you own. Just get the cheapest plastic toilet seat from Walmart for $5 or so and a:

Product not found | DSHOP

Something went wrong
www.dshop.com.au
or buy ready made. Only weighs a pound or two max and you can just use garbage bags insted of the pot.

Amazon.com : Elite Portable Camping Toilet, Travel Toilet Collapsible & Flat Folding Toilet Chair & Toilet Seat for Adults, PortaPotty Commode Chair, Car, Camper, Trailer, Lightweight, Hiking : Sports & Outdoors

Amazon.com : Elite Portable Camping Toilet, Travel Toilet Collapsible & Flat Folding Toilet Chair & Toilet Seat for Adults, PortaPotty Commode Chair, Car, Camper, Trailer, Lightweight, Hiking : Sports & Outdoors
www.amazon.com

Foldable Stainless Potty Chair Bedside Bathroom Toilet Commode Seat Shower Potty | Wish

Buy Foldable Stainless Potty Chair Bedside Bathroom Toilet Commode Seat Shower Potty at Wish - Shopping Made Fun
www.googleadservices.com
 
tribal said:
Yepper, a porta-potty.
Sadly, i have ****canned the ****ter as it was too bulky and heavy for my rig.

Too bad as i put a lot of effort into customizing it and used up all my decals...
Click to expand...
A roll of scotts and youre good to go, remember Jim never trust a fart and youll be ok.
 

Ha Ha, yes I rushed the wrap job and didn't have my heat gun.
That chrome vinyl is hard to use on compound curves. I purposely didn't post closeups of my feeble first attempts on Black Mamba.
It is for more experienced wrappers.

My buddy gave me his old foldup WDS (waste disposal system) - I swapped 21lb medium-tech biodegradable crapper for a low-tech 1lb unit.
TMI but it is broken in. LOL
 
Hi all
Junked the Innovate air/fuel gauge, changed 2 sensors before it became apparent it was the gauge at fault (internet search revealed problems )replaced with a AEM unit all good so far
 
Turned over 40K miles on my 2010 Roadie bought 5/24/10. Not a lot of miles, but in my defense I have 4 other bikes and for a while there my '09 DR650 was my go to travel bike.
Starter relay went at 1K miles because, as it turns out, mine was a very early Roadster that didn't have the updated subharness. I had a shift seal replaced and a couple minor cosmetic things done under warranty. Incorrect assembly by the shop meant my front ABS wire got chewed through at ~15K miles. My valve cover gasket needed replacing after I checked valve clearances at 19K miles (all fine). I replaced a few ECM and fuel pump relays over the years, but the problem actually turned out to be a bad main fuse holder I replaced for $4 from O'Reilly's. Only took me a few years to figure that out. Duh.
So, out of pocket for a valve cover gasket that may have been my fault and $4 for a fuse holder in 40K miles. Not too bad.
Wanted to add too, this oil change will be the first I've paid for because the shop I bought it from gave free oil changes for life right up until they closed.
 
Last edited:
You must log in or register to reply here.

Similar threads

  • Poll
Do you change your oil when storing your Rocket? [Another Oil Change Thread]
Replies
5
Views
355
Gregger
What Ryder safety tip helped you today?
2
Replies
13
Views
630
1olbull
Did the rear tire today.
2
Replies
10
Views
944
Kevin frazier
Just inherited today
Replies
4
Views
245
Mongler07
Evil Knievel Rocket 3 Edition
Replies
9
Views
558
Vector
Menu
Log in
Register