Switched wire to tap into

Hello, I'm looking to wire up a pair of amber running lights on my 2025 Rocket 3 GT - I plan to use the innovv power hub to provide power to the light only when ignition is on.
This power hub is wired to the battery directly, but has a trigger wire that signals whether the ignition is on or not

On my prior motorcycle (Harley), I tapped into the rear tail light (which was on only when ignition was on) - the power hub also delays power output for 10 seconds after ignition is on (to prevent overload).

On the Rocket 3, is there a wire under the seat that can be tapped into for this?

Should have made it easier and gotten: Healtech Advanced Power Distribution Module Connect More Accessories TB-U02 | eBay

While it can run off a signalling wire, yet it has internal logic to detect when bike is on.

There is also a cheaper ~$60 version that has one rail: Healtech Advanced Power Distribution Module TB-U01 Connect More Accessories | eBay

These are so small and convenient, I don't use anything else (until I find something better).

I have a healtech, but used the acc. switch to bypass auto off. I found this plug and tapped into it to avoid cutting into any wires. It's on the left side, hidden along the edge. Probably plug for Bluetooth? Anyways, it's just capped off on mine. Just de-pin the acc wire, and plug your wire in to get acc power

edgeofsanity said:

I have a healtech, but used the acc. switch to bypass auto off. I found this plug and tapped into it to avoid cutting into any wires. It's on the left side, hidden along the edge. Probably plug for Bluetooth? Anyways, it's just capped off on mine. Just de-pin the acc wire, and plug your wire in to get acc power

Click to expand...

Thank you! The pictures are very helpful