Second TPS

petaksmetak

.020 Over
Joined
Aug 28, 2012
Messages
22
Location
Zlín
Hello,

I have a problem with second TPS.

I changed primary TPS (high idle speed) and while changing I took out second TPS (I mistook these two - I thought that the one I took out is the first one but it was the second one).

Now, there is an alarm of TUNE ECU - secondary TPS low voltage and high voltage.

What is wrong and what happened when installing the second one? First one is OK ( firstly changed), second was taken out and put back again.

thank you

Petr
 
Is it possible that you bent the connection or otherwise disturbed the sensor ports? You may be able to simply remove it again, clean it and replace it. I am not sure if this will correct the error you are getting but worth a try if for no other reason than to reinspect the TPS once more.
 
idk said:
The secondary TPS needs to be wound against its spring and then inserted and set otherwise it will throw the CEL voltage code.
Click to expand...

Thanks for the advice, you can not describe it in detail?
(secondary TPS needs to be wound against its spring and then inserted)

My English is very bad.

Thanks from Czech Republic
 
Tonight I tried to put the sensor normally again - the tension was 4,85V.


I tried to put the sensor rotated 100 degrees and then push and tension was O, 62V at 0% trottle. Upon starting the motorbikes voltage 1,95V trottle was 38%.


But it still glows yellow motor alarm. A error P0223 and P0222 error.


It is set up correctly? changes value when turning the potentiometer TPS.
Or it is necessary to erase a mistake?


I can ride a motorbike with this error?
Thank you.
 
Now is everything OK. I erased error code, TPS is set with ISCV in Tune ECU. Now no error is displey.

Thanks for advise.
 
You must log in or register to reply here.

Similar threads

Operation overhaul starts, first on the menu, TPS settings at closed throttle.
Replies
4
Views
250
Zanx
Error Code P0122 - TPS
Replies
2
Views
689
spb2002
Possibly TPS failure?
Replies
7
Views
983
Gregger
Tps % at full throttle
Replies
2
Views
684
bebsy
TPS or stepper
2 3
Replies
22
Views
3K
Cor