Running rough after tank swap

Its 3bar, the tester hose should connect to tank and youll need new crush washers, its a simple fast test and youll know for sure, it should hold and if it falls fast theres a problem in the tank or speratic, but if good steady and strong that can be eliminated and maybe trash in an injector but the inside of tank probably good.
 
Check the low tension connections to the coils ( crimped tight), the vacuum hoses, and the spark plug leads. I suspect you disturbed something under the tank.

Also check the two hoses that attach to the tank. Are they crimped somewhere? Are they attached to the correct spot?
 
just because u may have 45 psi does not mean u can flow enough gas to run above above idle.
it should flow a gallon of gas pdq
 
if u remove the fuel connecter could u tell me what the voltage is on pin #4 key on engine off
never mind it will set a code
 
Checked coil wires and they all seem good.

Battery is putting out 13.4v while running.

Hoses and lines on throttle bodies were all good as well.

Next will be the pressure test.

Thanks again everyone!
 
You must log in or register to reply here.

Similar threads

Roadster tank
Replies
2
Views
300
Ratty79
09 running rough
Replies
8
Views
557
Mongler07
Roadster tank on Classic
Replies
3
Views
342
heinrichsmit
Lining/Sealing 2015 Rocket three Fuel Tank.
2
Replies
10
Views
987
Mongler07
Sump pan bolt torque value
Replies
2
Views
176
xlozinguez
Menu
Log in
Register