RIIIR and Rivco plate relocation

Evil Mitch said:

When u install it to make life easier you will notice some nuts under the rear gaurd that hold the tail light on. Undo these nuts and remove tail light and it will expose two little metal plates that have the threads on them you need to mount the numberplate bracket to. Pull them out then locate your numberplate bracket and then put the little plates with threads back in locating them thru the holes in the np bracket and put the nuts back on. If you try it without removing the tail light it's a prick to get in there but with the tail light out its a breeze . Mitch

Click to expand...

Evil Mitch said:

Yep it will work fine mate same setup as standard/classic rocket

Click to expand...

Evil Mitch said:

When u install it to make life easier you will notice some nuts under the rear gaurd that hold the tail light on. Undo these nuts and remove tail light and it will expose two little metal plates that have the threads on them you need to mount the numberplate bracket to. Pull them out then locate your numberplate bracket and then put the little plates with threads back in locating them thru the holes in the np bracket and put the nuts back on. If you try it without removing the tail light it's a prick to get in there but with the tail light out its a breeze . Mitch

Click to expand...

General Havok said:

Thanks Evil! That's exactly the info I was looking for. Thanks for going the extra mile and explaining with such detail. This forum rocks!

[Honorable mention to TOMCAT for verification]

Click to expand...