Matt15
.020 Over
- Joined
- Oct 29, 2023
- Messages
- 14
- Ride
- Rocket 3
Alright, this is probably a really long shot but... . Does anyone make raked neck bearing cups for a rocket III.?
Reason I ask is because I'm wanting to rake my rocket about 3 degrees. I'm worried if I get raked trees they might make my trail far too low. But if I used raked bearing cups I would actually gain trail as it's basically same as cutting and raking the neck . I know with more trail steering does become difficult but I'd rather that than having steering that's way too light from raked trees.
Also the reason I want to rake is because I'd like to lower my rocket a couple of inches, front and rear. At the moment at stock height I can see that the front tyre is going to clip the radiator if I was to lower it. So I'm assuming if I pushed the front end out a small amount it would allow me to achieve the lowered stance I'd like and should still clear the radiator.
Any replies would be great.
Reason I ask is because I'm wanting to rake my rocket about 3 degrees. I'm worried if I get raked trees they might make my trail far too low. But if I used raked bearing cups I would actually gain trail as it's basically same as cutting and raking the neck . I know with more trail steering does become difficult but I'd rather that than having steering that's way too light from raked trees.
Also the reason I want to rake is because I'd like to lower my rocket a couple of inches, front and rear. At the moment at stock height I can see that the front tyre is going to clip the radiator if I was to lower it. So I'm assuming if I pushed the front end out a small amount it would allow me to achieve the lowered stance I'd like and should still clear the radiator.
Any replies would be great.
