PCV +AT Issue

[R3Tex]

Thought I would throw this up for more of a place holder than anything else, but here's the issue...my auto tune doesn't seem to be talking to my PCV and it's throwing a "2303 - VR Module - Signal Unsynced" error code. Just got off the phone with Hanso and we have some ideas but will also be talking to DynoJet tomorrow to figure out the error code. I'll update the post when I figure it out.

 

[R3Tex]

Just spoke to Dynojet tech support and apparently the 2303 error code is nothing to worry about. It has something to do with the voltage feedback loop on Triumph being ass backwards to every other manufacturer but is not supposed to affect drivability. I am going to double check all connections, software and firmware versions this afternoon and then get online with their desktop support folks. More later...

 

[R3Tex]

Final installation on this thread...this is where I get to publicly admit a bonehead move. When I hooked up the AT I put the wrong plug in the empty port. one of them that comes in the package is just a dumb rubber plug the other however is required or the AT won't function. The one that is required looks just like the connectors on the CAN cable. It apparently has some hidden wiring inside that completes the circuit. All is well now...no more error codes and I finally got some data on the trim table. Now all I need to do is complete the tuning tweaks and everything will be everything as the saying goes

 

[HansO]

As per e-mail Great Stuff You had me stumped there after you had told me the plugs were all in correctly, glad you realised that the can type plug was the right one for the AT, you must not have heard me over the noise of your bike running when I described it to you.... now go out there and enjoy!!!!