Working on it. I did primer, epoxy paint then Plasti-Dip and when I sprayed the Plasti-Dip it separated bad so I had to strip everything and start over. Either the epoxy wasn't fully dry or the Plasti-Dip was old, it's been around for years. I'm giving everything 24 hours to dry this time.
Finally finished painting the Claw and screens. The Bearclaw has been a total PITA trying to get a decent looking paint coverage. Here it is, not perfect but
looking good. I'm leaving it out in the sun to fully cure the paint so day after tomorrow I'll install the screens and fit it to the motorcycle.
I'm very happy with the results. Should let it breath cool air rather than hot over the engine air and it also should give
some protection from heavy rain.