I need a picture posted of where the bearclaw mounts

[barbagris]

...I think the Brits designed the BearClaws fasteners just to piss us off; across the pond......

Think? - Must be true - This Brit has no problems plopping the claw on and off.

 

[barbagris]

The bearclaw rear mount is pointed up the tank rear mount is facing out. The front mounts are spaced apart.'
Any help would be appreciated

Your bearclaw is missing the central rubber block for a start.

 

[Blastedbones]

:lol: dunno what Will has against the Claw!!! piece of piss to fit! . The mounts you are looking for in the photo, are above the little sensor filter, & behind the last K&N air filter. As Barb said,

Your bearclaw is missing the central rubber block for a start.

but that shouldn't be too much of a problem, it's just a push fit in the middle tabs.
Frount bolt goes in horizontal pointing backward & rear goes vertical pointing up. You should only have 2 brackets to bolt onto the tank to allow for this, how hard can it be???

 

[Blastedbones]

:lol: dunno what Will has against the Claw!!! piece of piss to fit! . The mounts you are looking for in the photo, are above the little sensor filter, & behind the last K&N air filter. As Barb said,

Your bearclaw is missing the central rubber block for a start.

but that shouldn't be too much of a problem, it's just a push fit in the middle tabs.
Frount bolt goes in horizontal pointing backward & rear goes vertical pointing up. You should only have 2 brackets to bolt onto the tank to allow for this, how hard can it be???

 

[tdragger]

Hopefully this answers your request:

Front:



Back:

 

[Bluemarlin]

Thanks TD, just what I needed.