Camshaft relearn P0315 using TuneECU

Kirstyfrog41 said:

Hi, I have a Triumph Rocket 3 TFC, I have flashed the ECU via TuneECU software & remapped the bike. As a consequence of doing this two fault codes have arisen. One was for cruise control which I have now sorted, the other is P0315 crankshaft relearn. I've tried looking on the internet YouTube to see if there are videos of step by step procedures of clearing this code using TuneECU. Unfortunately I cannot find a single video showing the step by step procedure.
Can anyone help me?

Click to expand...

atomsplitter said:

You should be able to just clear the fault with TuneECU. If it's a real problem (not a glitch) it'll come back on (fault code), Then it's manual time and investigate what it takes to clear the actual problem.

Click to expand...

The P0315 code indicates that the crankshaft position system variation has not been learned. To fix this code on a Triumph Rocket 3, you can try the following steps:

1. Select Crankshaft Position Adaption and click Start
2. Follow the on-screen instructions
3. When the adaption is complete, click Finish and turn off the motorcycle's ignition switch
4. Wait at least 60 seconds for the motorcycle's electronic system to power down
5. Turn the ignition switch back on and check that the P0315 code and the MIL have clear

Click to expand...

Bob R said:

Here is an idea.

Engine Code P0315 error - SOLVED!

So I loaded the Penner tune yesterday with TuneECU, it loaded fine. I am not sure which version of the instructions I was reading, but it talked about resetting the adaptations, which I did, and now the bike is throwing a crank position code, P0315. It also threw a cruise control code, but the...

www.r3owners.net

Here is what your friendly AI says:

bob

Click to expand...