Wife and I purchased the bike in July of 2012. At that time, I personally installed the following items:
-Triumph leather saddle bags (with internal frames) and brackets
-Triumph windshield with Triumph front end fixing kit (mounting hardware)
-Triumph tall sissy bar with touring backrest...
I am considering trading my '07 R3 for a new Roadster.
The dealer principle tells me that Triumph have sorted out the rubbish fuel sender, and that the Roadster has "distance to empty, consumption etc. etc" and all is good.
A friend "in high places" ;) tells me this is BS and the sender is...
...Thats the bad news. The good news is that I was traveling very slowly so my only real injury (despite my pride) was a "bent back thumb" and some general soreness. I have not had a chance to fully evaluate bike damage as I am at work...but I learned something valuable about cast...
I’ll start off by saying my bike is a 2012 Roadster with about 4,500 miles on it. I’ve put around 200 miles on it myself. The bike was purchased as a leftover on 4/2014, so it’s still under warranty until 4/2016. Here’s a few things I’ve noticed in my short ownership.
1.) The heat shield...
Hello All.
I am looking for a set of risers for a 2014 Roadster.
Rivco is the only brand I can find that gives a few inches of pullback but if there are other riser or bar replacements that people have that would do the same I am open to it.
Cheers and thanks
hello everyone,
new to triumph rolling down the road today and bike just stalled was able to coast to safety also thankfully had a friend help get it on a trailer get it in the garage. has only 1300 miles and just a few weeks ago had its first service last night i did drive it quite a bit with...
Here is my dyno results, blue is standard Triumph map, red is map created on dyno machine. Mods: straight through exhaust cans with cross over, standard header, k&n under seat filter. pops a little on deceleration as expected, but not too bad. Noticeable improvement in driveability ...
Does one exist? I found one video on youtube but it's from the front of the bike, so you can't really get the full effect. There's a great video of the older 3 pipe TORS, but I cannot find anything from the newer 2 pipe TORS for the Roadster.
so I am the proud new owner of a rocket III roadster. I used to ride a R3T but have decided to see how the other half lives :)
I am interested in understanding what everyone does for wind protection. I tried ridding with the stock windshield and the clearview but actually prefer it without a...
so I am the proud new owner of a rocket III roadster. I used to ride a R3T but have decided to see how the other half lives :)
I am interested in understanding what everyone does for wind protection. I tried ridding with the stock windshield and the clearview but actually prefer it without a...
I have a like new (less than 200 miles on the road) kit to transform your Rocket 3 Roadster into a floorboard setup. This is the setup with the higher rails and angled floorboards that doesn't significantly reduce your lean angle.
I installed the complete setup as shown in the photos and...
Hi all, anyone know where I can source a free soft copy of the roadster workshop manual?
I want to do some minor tinkering and it helps to know the right way to lift the tank, take off and refit the back wheel, fit optima the connections, torque settings, etc
Thanks
I really like the digital display on the tach side of the roadster and was wondering if anyone here has fitted one on a standard and if it works or can be made to work. A gas gauge and clock would be nice on the long rides.
Triumph Rocket 3 Roadster - 2010
# 1 Owner
# Always Garaged
# Reg til Oct15
# Matt Black Colour
# Triumph Saddlebags, Sissy bar and Pillion Back Rest
# Triumph Touring Gel Seat with Rider Back Rest(original also supplied)
# Number Plate Relocation Kit
# Kuryakyn Grips with Dagger Levers
#...
Ok, 2014 Roadster, homemade tors, (big drill bit and a bit of cutting and welding)
Got the cable en route.
Where can I get a tors tune or is there something better for otherwise stock bike.
I have tuneecu installed on my computer and have read some of the tutorials, but still feel like a monkey...
Hi guys, converted from 1000cc sports bikes, i took the plunge and purchased a 2011 roadster, burgandy and black version... Pretty happy so far, just need to get out more...
I am looking for the bracket (like the one in the below picture) used on the pillion seat of a 2010 to present Rocket 3 Roadster. If anyone has upgraded to a custom seat or 2 up type seat and has no use for the pillion, please let me know if you are willing to sell it. Since I just want the...
Just noticed these on ebay, if anyone is interested and want them sighted before purchase let me know as they are 10 minutes or so from me
http://rover.ebay.com/rover/1/705-53470-19255-0/1?icep_ff3=2&toolid=10001&campid=5335943355&icep_item=251878659060...