The bike has been running rough so I changed the fuel filter and spark plugs. It seems to be running better, however I ran it and the engine warning light stayed on. I checked it with TuneECU and got the PD353 - Ignition Coil 3 circuit malfunction error.
Has anyone come across this before and...
Well, my old 05, with over 60,000 miles, finally did the melt the wire off the ignition switch. Already soldered back on, now for adding a relay and upgrade wiring.
DEcosse KeyLess Ignition System - Relay Kit Version
For Plug n Play Installation
Link Removed
Kit includes all per original supplied equipment
KeyLess Controller
RFID Antenna
Power Relay Harness
Alarm Extender harness
TWO RFID Remotes
Link to Original Installation guide included.
Harness...
OK,
@DEcosse has been very helpful in the past answering some of my questions and I finally got around to giving this a try. My first few attempts yielded mixed results as my schematic was off. While I haven't given this one a try, I think I finally got it right.
I'm using the following...
Been researching the timing tables. Downloaded the tables the bike was delivered with and find that the advance is delayed a bit or different for 1st and 2nd gear than the rest. Does anyone know why?
It has been recommended to copy the upper gears table to the lower, which I have done as...
Believe it or not, I have to giggle the key until the headlight stays on and than it will start.
Other than replacing the key switch assembly, does anyone know how to fix it.
Maybe some lub down the keyway?????
Is anyone familiar with the specs of the r3 coils, such as the primary resistance,sec. resistance,inductance, max. voltage, turns ratio.
The workshopmanual is not so specific about these.Why I want to know ?Because I intend to put in more sparkpower under full chargerboost with coils of for...
Has anyone installed the EB ignition switch/headlight relay on their Touring? My son and I installed it on my 07 Classic about a year after I gave it to him with a set of very clear installation instructions authored by Mexican several years ago. It looked daunting at first but turned out to...
This is torque graph in Nm (250 is about 185 ftlb) with different ignition advances. (10-30 degrees BTDC). It was done at WOT with a Rocket Roadster that had high compression pistons, cams and open intake and exhaust. If you got something similar, you should not only take care of fueling but...
I have just purchased a PCV and will install my Viking exhaust and Ram Air unit. I believe modifications would be needed to the iginition as well as the fuel curve. Although I've haven't heard anyone mention ignition adjustments for the Rocket.
My question is, if spark curves need to be...
Having a PCV and AT200 already with a @HansO tune, I presume this could only be of use when using a dyno and somebody who knows a little more about tuning than just fueling. Is there any point to using one without engine modifications?
Dynojet Power Commander V Ignition Module #6-103 Triumph...
I need to install my new ignition switch. I need advise on how to preform this surgery before pulling everything apart. I installed the EB kit without a problem but when looking around, it seems there must be a trick or two involved with getting the old one out and new one in. Locating the...
just a quick reminder if any one for any reason orders a new ignition barrel .. beside the criminal amount of money required for this little part DO NOT THROW AWAY THE OLD KEY ,, because in it wisdom triumph made the side lock for the seat non generic the new key WILL NOT pop the seat off...
I have a 2005 beauty. She is beginning to have an electrical issue. This weekend, I fired her up and all was well but died within two to three seconds where everyting was dead, no lights nothing. I turned the key off then back on and nothing, No lights no sweep. I turned the key off and I...
Has anybody installed a keyless ignition on their Rocket? My bike has this nice batwing fairing but it makes access to the ignition a little tricky and tight. I was thinking about a keyless system like Digital Guard Dawg. Anybody installed something like this and have issues or was everything good?
HI looking for an answer here. And hope question is clear.
I have always thought that the "I" tables in the ECU mapping were for each cylinder (like the F-L tables).
Now I am not so sure as I looked at some Thruxton, Thunderbird and TB Storm maps. They all have 2 cylinders and, as expected...
I had an Awesome day today went on the first decent ride I have had in a while (been either to busy working or the weather has been up to crap), all my recent rides have only been short ones to neighboring towns to have a coffee or a catch up with mates.
Well today I had the pleasure of...