Here is link to Maggies full view after installing the Zard exhaust (racing, no baffles) along with the carbon fibre heat shields. Also installed Corbin seated (heated).
I have done a search and did not find a specific post on this, so please forgive me if it has already been addressed. I am looking for a good source (I am in the U.S.) for exhaust manifold gaskets. TIA
Question:
I'm looking at having a TTS Stage 1 supercharger installed on my 2015 R3 Roadster. Right now, it has RamAir already installed, and a cheap slip-on exhaust, right-side only. I'm looking for something a little bit more like the stock exhaust, which I actually like the look of, but I...
Look folks you can buy the big bad racing systems from New Jersey and fry your legs. Of Course You can go with the home brew exhaust which is a joke. Or you can buy a tuned exhaust system from Viking exhaust and be done with it. Trailer Queens will disagree. They are the folks that talk but do...
Just looking for some input. Any experiences with or opinions of exhaust wrap? I have an ‘06 classic with carpenter racing exhaust and the burn is just too much. I’ve seen the posts about wearing protective pads but I’m tired of the scorch marks on my jeans and I don’t want another piece of...
Hi guys, just got the rocket back on road only for someone to pull out in front of me. Long story short both me and the bike went flying. Given 3rd party was the issue I'm making a claim given with clothing and repairs its gonna be in excess of 2.5k. Now what I'm thinking as I'm gonna need left...
Hi, Has anyone got a way of stopping the exhaust header pipes on the RHS burning a hole in my wet weather gear just below the knee, it has happened twice now?
Cheers
HB
Evening Everybody,
Just picked up the bike from G P Bikes in Melbourne, FL after getting new tires put on and dyno tuned.
2011 Roadster with Ramair and full 3:1 Viking Exhaust.
20355 KN TORS.hex map used as base.
Initial pull: 143.16 HP & 145.47 ft-lbs
Final Result: 147.21 HP & 152.66 ft-lbs...
Any exhaust options out there yet for the GT or R to give it a more deeper sound?
My 16 Rocket 3 Roadster had the aftermarket TORS exhaust and had a nice deep rumble to it. My only negative on my 20 Rocket 3 GT is it really has no sound.
Hi all i am after some guidance please , I have a 2016 roadster which has Dave platt outlaw exhausts all ready fitted , I am going to fit a ram air filter and would like to tune it is there a good tune I can upload using tune ecu or is it best to take it to a dyno shop ? ,
Just rockets at...
Hello' I am a new member. Have a R3 touring. Purchased a ramair filter upgrade kit. Will be purchasing aftermarket exhaust silencers, to remove stock mufflers while keeping stock manifold. Currently have installed a O2 sensor removal kit. Question being what tunes are available or best for this...
I noticed a hairline crack on the middle (#2) header almost two weeks ago.
The crack is approximately parallel to the engine face along the exhaust ports. Its jagged appearance indicates that it might well have started as a shorter (hydroforming-related) stress fracture from where it then...
Good Morning Everyone,
I recently installed Paul's Viking Header exhaust, and when I installed it, I saw that the factory gaskets were still inside the ports, so I went ahead an put on the new header. When I did this, I made sure to make sure it hadn't rolled downward, and I thought I had it...
I've seen posts in some threads on here that the exhaust cam clearances increase rather than decrease with miles ridden. Is that right? Yes the exhaust cam clearances are greater than the intake, but both valve wear in the same way don't they, snap closing each time? So the statement that...
Hey guys. Loving my Rocket 3 Touring so far and with it garaged up for the winter, I was starting to look at a new exhaust. My last bike, a 2004 Kawasaki Vulcan 1600 had a deal where the stock pipes were hollowed out with a new collection kit to give it a more throaty sound but not straight pipe...