Hello,
I have penner map flashed.
I have ridden 800km on new penner map.
After 800KM RIDE ON PENNER MAP I have noticed 3 times in city/parking lot ride that while I am doing low speed ride roll/move/ride in parking lot or road in 1 or 2 or 3rd gear or while changing gear. The engine just shuts...
So today I was returning from visiting my sons at college. I was riding about 85-90 on the interstate and suddenly the speedo dropped from 90 to 20 and the bike started hesitating. I had just filled up. For the next 5 minutes or so the speedo would periodically jump back to 80+ and it would run...
Hello,
I want to know how will someone know that he is messing the piston rings or engine altogether on rocket3r 2020+?
I got werkes exhaust at 5500km and now bike is 8500km.
After getting werkes exhaust I did intermittent rev bouncing, open close throttle to red line RPM while riding or when...
In this area (red circle) I see some oil (or other liquid) marks.
Question: what is covered under chromium cap? Might be some liquid leaking from this place? What it is, as I do not find any info in service manual?
Brand new 2022 Rocket 3R, had my 600 mile maintenance done at 700 with the dealership, just over 1,000 miles and I rode her hard and fast for about 3 hours averaging 97mph 140 top low about 67mph. After my trip I noticed it doesnt sound good at idle anymore or at low revs as there is distince...
gonna share an engine build from cases being prepped to hopefully a successful launch. Step 1. Deck surfaces, 15 thou on head, block flat surface. Install all new bearings on this build as this motor is gonna live in widowmaker, i hope. Lets build one.
I’ve always heard that the grey or silver engines were only in the 04 and 05 years. yesterday I saw a 07 posted for sale with the light colored engine. When I questioned the guy he said it was a 07 purchased like that. Any ideas?
hello R3 owners,
I am wondering if revving up engine at 5500rpm to make louder sound by exhaust when bike is not in gear and not in motion bad for engine? Something like what this guy is doing in video but at higher RPMs.
If its not good then what could happen to engine if you do it often...
So I loaded the Penner tune yesterday with TuneECU, it loaded fine. I am not sure which version of the instructions I was reading, but it talked about resetting the adaptations, which I did, and now the bike is throwing a crank position code, P0315. It also threw a cruise control code, but the...
Hi guys, looking for some advice. At 850 km my gt3 showed a check engine light. I booked it in for its first service. ( nearest dealer is a 4 hour ride away) 2 days later it was harder to start than normal, and was blowing some Grey/ black some. Check engine light came on again. Rode it back to...
Help finding a product (that I'm not sure exists) in the US! I've been searching for some time now! I know it's been referred to on this site, but all links are down & (as far as I can tell) the sources are international, making procurement basically impossible in this COVID environment.
*I'm...
My 2020 Rocket 3R engine has been very smooth for it's first 17,000 km. For the last 3,000 km I've been experiencing a high frequency vibration in the handle bars, foot pegs and seat. The vibration can be felt at any revs but is more noticeable from 4000 rpm. Vibration is felt when moving or...
Good morning people.
I have had my 2014 Roadster with 12800 miles on it parked up for 2 months and today noticed a very small oil patch on the floor which appears to be from the breather pipe under the engine. The pipe has an oil mist around it so i assume this may be just normal? I hav'nt...
If I restart it goes away most of the time. Maybe I have to turn off for a minute or so. I just changed out the ignition due to the jiggle/off known issue. I also recently had it serviced at the dealership and now it drives crooked ever since I got new tires put on. This bike is posing more...
After a nice ride I stopped about 20 minutes from home to clean bike. After getting back on engine light showed. I pulled over, did walk around as bike idled, no leaking, no change in sound. Turned bike off. Checked oil, full.
Drove home, at lights trying to tell if radiator fan turned on. Not...
Hi, I'need to remove and split the cases because the bolt from the gear selector rods has fallen. Can you please let me know what triumph special tools are needed for the operation? Many thanks
I have a 2013 R3 Touring and have excessive heat coming off the engine on the Left side. It's as if the radiator is directing the heat over the engine and out that side.
Any suggestions on how to redirect this heat as it is hitting the underside of my thigh to the point of causing a blister or...