ecu

Replaced my ECU with a brand new one but the bike will run only a second or two before it dies. All needles sweep, fuel pump pressurizes normally and it fires immediately but dies after the time stated above. I did an adaptive reset before attempting a start and have no error codes. The...

So I am trying to help someone who has a Power Commander on their Rocket right now. He wants to add the Ramair. He wants me to up load a new tune via Tune ECU and ditch the PCIII. So what I was thinking is uploading the new tune and leaving the Power Commander in place, then when he gets the...

Just have a question here, are the ECU's on the touring and roadster different or the same, main reason for asking would be, can you use the same tune on each one or are they different and you have to use a tune specific to each model?

Could someone send me a copy for my laptop?

Anyone know of a dyno that can work with tune ECU on the east coast. I'm in SC about 50 miles south of Charlotte Thanks

Hi I'm new to the rocket scene just looking for a map to go with my 2008 classic its had a decat and o2 removed keeping the tors for now may change latter but I need the best map to use with the tune ecu lead etc or the latest whichever you guys think is the best Thanks Alan

Going mad, have bought a new longelec connector cable, downloaded Tune ECU, unzipped the file, downloaded the driver from Dx222.com used driver 2.12.26. Disconnect the wifi and unzipped the file and setup a new folder in C:/ Tune ECU Drivers. My problem is the drivers are not been reconised. i...

After having exhaustedly read many threads concerning tuneecu I have come to the conclusion that I may be the dumbest person in the world. While I remain utterly confused many others comment on the ease with which using the program to return thier Touring to somewhere close to what it should...

I want to swap to a pre-2014 roadster ECU so I can get the 9000 RPM map installed. I have looked through the parts sheets and the only change I can see are the speedometer listed with a different part number. The Tach is the same. All the sensors are the same. As far as I can tell the...

Hello all, does any one have an ECU for a 2010 Roadster they wish to sell? I have a customer with a need for one. If so PM me or email on nev@nevillelushracing.com Cheers Folks.

Okay this should be easily answered. I have many times balanced the throttle bodies on R3's, without the stock air box its pretty easy while using Tune ECU. No problems with this. From reading other threads I know that the vacuum hoses crack with age and may need replacing. I'm also OK with...

After a few weeks of messing around and pulling out the little bit of my remaining hair, I figured out why my cable/software didn't connect to the ecu. On my bike the headlight fuse also controls the instrument cluster. So the program must be sensing an error with the fuse out - since it can see...

Hi Guys, am a total newbie to the ECU tune and being in africa I lack the expertise locally to get it done. Is there some step to step guide to doing it yourself. Have the cable but don't know where to start. Have a R3 Classic 2006 all stock with the cat still installed. Would really appreciate...

So, I wanted to have my bike dyno'd so I had a Power Commander V installed. The A/F ratio has now been optimized for my mods and I'm going to load the PCV map into TuneECU so I can remove the PCV from the system. Is there anything specific that I need to know about removing it? I'll probably...

HI looking for an answer here. And hope question is clear. I have always thought that the "I" tables in the ECU mapping were for each cylinder (like the F-L tables). Now I am not so sure as I looked at some Thruxton, Thunderbird and TB Storm maps. They all have 2 cylinders and, as expected...

I just had the 30K mile service done on my 2005 Roadster. Once I got the bike back, I now notice a hesitation at around 1,800-2,200 RPM when the throttle is being lightly applied. The hesitation is not present when I am at or near full throttle. To me this screams TPS but I figured I would try...

Need some help ,I have a Lonelec adaptor and tune ecu works fine on my windows laptop,when I connect using adaptor usb lead to my mobile phone samsung S7 i can connect to ecu and green light appears at bottom when i select ecu i have four drop down menus but Tests and Adjustments is not...

I hooked everything up and tested the tach and fan and everything seemed to be good. I have a new ECU map that I was going to download. Went through the reset adaptation, then went through the ignition sequence and tried starting the bike and nothing. The starter button didn't do anything...

Is this correct ? Tricky Orange Tribal I have tune ECU Which i use on my 07 rocket If i try and use on my 2016 and ecu locked it will put the bike into limp home mode and will cost £300 to unlock.

Okay so I am about to installed the Ramair filter kit, I also have the ECU cable and what to tune it up. I keep hearing contradicting stories where the 15' ECU is locked and some say it isn't. Can anyone give me a straight answer? If it is locked how do I unlock it? If it's unlocked, I'm unsure...