Search results for query: *

  • Users: Pedro
  • Order by date
  1. Pedro

    Custom dyno tuning Melbourne

    Go and see Mr Lush you wont be sorry.
  2. Pedro

    Greetings from Aus with an issue

    Jumping can blow the 30 amp fuse. Also the bike will not run correctly if the battery is not good.Not enough power for the injectors etc.
  3. Pedro

    Lash caps after cam mod

    Its a long way from you .This guy is the man Chris at Precision Shims Australia Has lots and can make for you. www.precisionshims.com.au
  4. Pedro

    RESOLVED: 3 weeks troubleshooting, still stuck

    Was the engine running fine.before you changed the cam chain.Could you be one tooth out on the cam timing. Did you use the triumph tool to hold the cams .The slack in the chain needs to be taken up on the none tensioner side with the crank sprocket or it can be out .
  5. Pedro

    Driveshaft/rear axle maintenance

    170 mls is the correct amount of oil .For the 2.3 Rockets
  6. Pedro

    Power Commander 5 Install Question

    The bigger part of the plug is on the harness just at the back of the engine.That plugged into the crank position sensor that is at the bottom of the engine and at the rear of the engine. The PCV connector now goes between that connection joint , one part of the connector into the harness and...
  7. Pedro

    Power Commander 5 Install Question

    The other end
  8. Pedro

    Hydraulic clutch release went pop

    Can you tell me what is the part number for the correct orings for dot4 . Mine have been ok but better safe than sorry . Cheers
  9. Pedro

    No idle 2007 classic

    Check to see if the stepper motor linkage is connected to throttle and is being activated. May also be Primary TPS needs resetting or replacing
  10. Pedro

    Any closer ?

    Get rid of the bike mate,save yourself all the trouble
  11. Pedro

    Odometer Dead

    I replaced it with a OEM type.Had to get the full back face as they don't stock the black and gray anymore.
  12. Pedro

    Odometer Dead

    Mine did the same ,replaced the gauge
  13. Pedro

    Anyone guess what this is for

    Crank is part A,and balancer is part B
  14. Pedro

    TRR3 Roadster - Spongy Front Brake

    Tie back the brake leaver to the hand grip and leave over night .It may surprise you.You can use a cable tie or anything else that is easy to remove .
  15. Pedro

    Oil level drop in oil tank (Again)

    I have worked on 10 rockets the ones that drop usually do it over night. DONT worry enjoy the bike .
  16. Pedro

    Oil level drop in oil tank (Again)

    If you take the clutch cover off you will see a tube that oils the clutch basket.The oil slowly drips out of here until the oil tank is empty. I kid you not.
  17. Pedro

    Oil level drop in oil tank (Again)

    Some do and some dont . My bike is an 05 been like that from new .I start it and ride and I have a few engine mods on mine.Dont worry about it, check the oil after it has warned up and if its good no problem.
  18. Pedro

    PC Zero map question

    That will be fine,no problem.
Back
Top