R-III-R Turbo's latest activity
-
R-III-R Turbo replied to the thread Can a Rocket III take down the establishment, and rule this island.I'd love to ship it to the states and partake in some racing in "Mexico" too 😁 -
R-III-R Turbo replied to the thread Can a Rocket III take down the establishment, and rule this island.And the trans is back from Robinson Industries, full shebang. Billet 4th, undercut everything and circlip/groove upgrade. Probably gonna...
-
-
R-III-R Turbo replied to the thread Stepper replacement.Have you followed the Triumph manual step by step for stepper motor install and adjustments to its nut and TPS positioning?
-
R-III-R Turbo replied to the thread Stepper replacement.So the original problem was a rough idle, and after replacing the stepper motor now it won't start at all? Will need to start with...
-
R-III-R Turbo replied to the thread Clutch stuff.Can't think of a good thread off hand, but from memory the bearing on the torsional damper was installed backwards from factory. So the...
-
R-III-R Turbo replied to the thread Clutch stuff.Might have more than one issue. The 2nd being the clutch dragging a bit. Is the clutch cable adjusted to 2-3mm free play, as per manual...
-
R-III-R Turbo replied to the thread Clutch stuff.Does the noise go when you pull in the clutch lever while decelerating?
-
R-III-R Turbo replied to the thread Stepper replacement.Why did you replace the stepper?
-
R-III-R Turbo replied to the thread Stator bolt rotation when removing.Yeah "normal" bolt right hand thread. Open counter clockwise. But you need to stop the crank from turning with something quite strong...
-
R-III-R Turbo replied to the thread Stator bolt rotation when removing.It's an M12 right hand thread but will need to measure one at home to know thread pitch. What's happening when you go to remove it?
-
R-III-R Turbo replied to the thread Stator bolt rotation when removing.Sorry, what's the problem?
-
R-III-R Turbo replied to the thread Operation overhaul starts, first on the menu, TPS settings at closed throttle..You should have 0% when throttle fully closed First check you have free play on throttle cables as per the manual. If still not zero...
-
R-III-R Turbo replied to the thread Can a Rocket III take down the establishment, and rule this island.So the trans is on it's way to Bill of Robinson Industries Inc. in New York. Meanwhile, some repair work on the Hayabusa head and...
-
-
R-III-R Turbo replied to the thread PC on a 2004 R3?.PC maps can be adjusted while the bike is running, immediate effect. ECU has to have engine off and takes ages in comparison to load...
-
R-III-R Turbo replied to the thread Front brake disks (rotors) with ABS replacement.I had Triumph rotors and Brembo pads for years before this so didn't notice anything radical when moving to Brembo rotors too
