Recent content by EwoutR3

  1. EwoutR3

    No Power When Ignition Turned to On

    You can try to jump start it with a car next to it. But when the battery is really gone, it won't even start that way.
  2. EwoutR3

    No Power When Ignition Turned to On

    can be dead anyway, check with voltmeter while cranking. It should not drop too much.
  3. EwoutR3

    No Power When Ignition Turned to On

    The battery is oke...?
  4. EwoutR3

    Will a ram air and tune ECU make much difference?

    not really, I think for that kind of difference you have to dig deeper in your pocket.
  5. EwoutR3

    Will a ram air and tune ECU make much difference?

    Hi, I have 2010 roadster too, with Ram, open sec's and Mapping 20355. Top speed is ±7-8 km/h higher, the difference is mainly that it runs a bit nicer, less deceleration popping. Uses a little more fuel, 1 liter at 14 km compared to 1L:15km average. Intake sound is different, I like it...
  6. EwoutR3

    Ecu problem?

    Did you use a relais for the plate flipper?
  7. EwoutR3

    My click click starter saga

    Yes, but that's not the wire I mean. Your wire (I think) is the wire that I drew in the picture. There should be a wire from battery+ to the starter in the harness. The one in the top that I put an oval around. Maybe there is a problem? A couple of times I had a similar issue with starting...
  8. EwoutR3

    My click click starter saga

    Well, more than one…. The starter relay is fed by the ignition switch via fuse 9. Also, the starter relay is connected to the starter switch, which is connected to the alarm control unit (you have that?) or to a harness link connector (when you don’t have the alarm unit). The alarm unit is...
  9. EwoutR3

    2005 Rocket Sport

    Another idea I have been thinking about. Never came further than thinking and searching some pictures though...:D More info than the pictures I don't have, unfortunately.
  10. EwoutR3

    My click click starter saga

    Great that you found a way to start her! I have been looking in the electrical circuit diagram. There is a blue-yellow wire that runs from the ignition switch (pin4) to the fuse box (fuse9) to the starter relais (pin1). That wire blue-yellow wire connects, through the starter relais, to the...
  11. EwoutR3

    New R3T owner in the Netherlands

    Welkom! Ik kan er ook maar geen genoeg van krijgen😁😁😁
  12. EwoutR3

    My click click starter saga

    Reading the electrical circuit diagram, I think clutch switch and side stand switch are connected to the ECM. Not to the starter circuit. The ECM controls wether to start or not based on the switch positions. Starter relais ground seems to go to the ECM as well (pin B24). So you cannot...
  13. EwoutR3

    My click click starter saga

    Yes, but I mean a separate wire from starter relay ground connection to the frame. That way bypassing the wiring harness, at least for that ground wire.
  14. EwoutR3

    My click click starter saga

    It's a difficult puzzle.... I have the same issue sometimes. That makes it hard to test voltage etc, next push on the starter button the bike could start perfectly normal. I am lucky it is only sometimes... Have you tried a new ground wire from starter relay to the frame? When everything related...
  15. EwoutR3

    My click click starter saga

    side stand switch? and all the wiring to the switches....?
See more
Back
Top