Recent content by ant

  1. ant

    Hydraulic clutch release went pop

    My plan was to purchase a complete seal kit from Oberon after they promised to send the O rings FOC. After a few emails they sent me an invoice for £30 for a incomplete seal kit. Oberon were not very helpful and wanted £149.99 for a new cylinder. After some searching on line i found on new...
  2. ant

    Oberon slave cylinder used in the TTS kits

    Thought i would post the drawing that Oberon sent to me with the seal kit. Thanks for the link if they worked for you then i will ordered a set. Thanks for your help.
  3. ant

    Oberon slave cylinder used in the TTS kits

    Hi Art, Thanks for your reply. Oberon sent the new replacement seal kit out to me on 04/02/2020 so they would have been fully aware of your issue. At the time they said it was unusual for the slave cylinder to have an issues so check for burrs in the casing as these could damage the o rings...
  4. ant

    Oberon slave cylinder used in the TTS kits

    Thanks for you reply Art. Strangely Oberon are still saying that they are unaware of the issue. They did however say that they would look for alternative O rings. I have told them of the issues here on the forum and your finding the EPDM version O rings. Ant
  5. ant

    Oberon slave cylinder used in the TTS kits

    Having clutch problems with a leaking slave cylinder. Looks to me like a O ring has failed. I know most of us with the Oberon Buell 1125 slave cylinder used on TTS supercharger kits have had a few problems. The latest problem for me was i noticed a lost of clutch fluid. On further investigation...
  6. ant

    Hello From USA

    Hello and welcome from a hot and sticky UK..:)
  7. ant

    Carpenter baffle?

    No i didn't use any wrap but like you say that would help... I don't have any rattling noise and the one fixing screw was enough.. To be honest it's takes a while to fit.....Cut a little at a time until you get a snug fit..
  8. ant

    Carpenter baffle?

    In the photo the top baffle is from Carpenter...The other is the Samson.. The Samson fits inside the exhaust around 4 or 5 inches..As you can see in the photo most of the cone has been removed.. Hope this helps you..
  9. ant

    Carpenter baffle?

    Yes you would need to trim the cone...No there are no instruction supplied.. I will take some photos later today if that will help..
  10. ant

    Carpenter baffle?

    I fitted a Samson A161....It requires cutting a little off the end as it's too long.. The carpenter baffle just didn't look right.
  11. ant

    New Bike...Just Down!

    Glad to hear you are on the mend...
  12. ant

    Hi all, new here

    Hello and welcome from down south....Looks a nice bike very low miles. If it was me i would go and check it and get a test ride...
  13. ant

    Nail In Front Tire!

    A few years ago when i was out riding my Aprilia Tuono 1000 i had puncture in the rear tyre.... It's just unbelievable what i pulled from the tyre...NO it wasn't the pen.
  14. ant

    Fork legs are pitted....Poor chrome ?

    So i have noticed that the lower part of the fork tubes are slightly pitted..It's only on the very lower part and is about 1 inch or so up from the casting. But it's only going to get worse. The plan is to get the tubes re-chromed and get the top tube and the lower casting powder coated...
  15. ant

    Hi from Basingstoke

    Hello and welcome...:)
See more
Back
Top